Abstract:Intelligent power management system is an important part of the smart grid, in which the non-intrusive load monitoring technology is one of the key technologies. However, most of the load monitoring methods regard this task as a multi-classification problem, thus it is not effective to identify the unknown loads that did not participate in training. In this paper, an adaptive non-intrusive load monitoring method based on feature fusion has been proposed which utilizes both information of harmonic current feature and voltage-current (V-I) trajectory feature. The harmonic current feature is obtained from the high-frequency load sampling data through Fast Fourier Transform (FFT). At the same time, the V-I trajectory feature is obtained by using the pre-trained convolutional autoencoder neural network that was trained for feature extraction on a public dataset. After the feature extraction, the similarity between these two feature vectors and the available feature vectors in the database is calculated by TOPSIS algorithm. Then the load monitoring can be carried out according to the similarity. When the maximum similarity is greater or equal than the set threshold, the load is considered to be one of the existing loads in the database, otherwise, it will be considered as a new type of load, and the load feature database will be updated. The autoencoder model is trained by using the V-I trajectory from the BLUED dataset and the PLAID dataset is used to verify the identification accuracy of the proposed algorithm by comparison with different algorithms. On the PLAID dataset, the identification accuracy can reach above 97%. Finally, on the embedded Linux system with STM32MP1 as the core, some household electrical appliances are used for validation in real house environment. The results show that the proposed method has improved the capability of load identification by using the complementarity of different features. It can be carried out in real time on embedded system and is able to identify the unknown load at the same time.

Real-Time Appliances Recognition for Non-Intrusive Load Monitoring Using Convolutional Neural Networks

A residual convolutional neural network with multi-block for appliance recognition in non-intrusive load identification

An Event-Driven Convolutional Neural Architecture for Non-Intrusive Load Monitoring of Residential Appliance

Adaptive Non-Intrusive Load Monitoring Based on Feature Fusion

A Multi-Head Convolutional Neural Network Based Non-Intrusive Load Monitoring Algorithm Under Dynamic Grid Voltage Conditions

A Scalable Real-Time Non-Intrusive Load Monitoring System for the Estimation of Household Appliance Power Consumption

Neural Network Ensembles to Real-time Identification of Plug-level Appliance Measurements

Real-time non-intrusive load monitoring: A light-weight and scalable approach

A Fusion Framework Using Integrated Neural Network Model for Non-Intrusive Load Monitoring

Non-Intrusive Load Monitoring with Fully Convolutional Networks

A Deep Learning Technique using Low Sampling rate for residential Non Intrusive Load Monitoring

Cloud-Based Non-Intrusive Leakage Current Detection for Residential Appliances

Multi-State Household Appliance Identification Based on Convolutional Neural Networks and Clustering

A Multi-objective Non-intrusive Load Monitoring Method Based on Deep Learning

Temporal and Spectral Feature Learning with Two-Stream Convolutional Neural Networks for Appliance Recognition in NILM

A Multi-Task Deep Learning Approach for Non-Intrusive Load Monitoring of Multiple Appliances

Non-intrusive load monitoring algorithm of residential users using limited low-frequency information

Low-Frequency Load Identification using CNN-BiLSTM Attention Mechanism

Non-Intrusive Load Monitoring for Residential Appliances with Ultra-Sparse Sample and Real-Time Computation

Non-Intrusive Load Monitoring by Load Trajectory and Multi-Feature Based on DCNN

Energy Disaggregation & Appliance Identification in a Smart Home: Transfer Learning enables Edge Computing