Abstract:Silicon has a theoretical capacity about 10 times that of graphite is expected to be one of the next-generation anode materials to further increase the capacity of batteries. However, silicon has a large volume change during charging and discharging, which result in poor cyclability. Although morphological change of silicon has been shown in a lot of previous studies, most of them are ex-situ observations using electron microscopes such as SEM and are two-dimensional observations 1) . Previous studies have shown that silicon may fulfill its potential as an all-solid-state battery anode material with the garnet oxide-based solid electrolyte 2) . Further understanding of the expansion and shrinkage mechanism of silicon is needed to improve battery performance using silicon anode. Synchrotron X-ray computed tomography (X-ray CT) is a technique that can measure the internal structure of a battery in three dimensions with micrometer-order spatial resolution in a short time. In addition, operando X-ray CT measurement is possible under charging and discharging in an all-solid-state battery 3) . In this study, we analyzed that morphological changes of silicon during charging and discharging by operando X-ray CT measurements. We used LiNi 1/3 Co 1/3 Mn 1/3 O 2 (NCM), Li 6 PS 5 Cl (LPSCl) and acetylene black (AB), which were mortar-mixed in a mass ratio of 1:1:0.1 as the cathode composite material, and Si, LPSCl and AB in a mass ratio of 1:2.78:0.42 as anode composite material. Si|LPSCl|NCM all-solid-state cells were assembled. X-ray CT measurements at SPring-8 BL20XU using 20 keV X-rays while performing constant current charge/discharge measurement at 2.3×10 -3 A cm -2 . The pixel resolution was 0.5 μm. A silicon particle was extracted from the X-ray CT images obtained from X-ray CT measurements to observe the morphological changes of silicon during the charging and discharging reaction. Cracks were observed in the silicon particle due to silicon shrinkage during the delithiation process. In addition, the silicon/solid electrolyte interface changed so that the silicon formed shell voids at the surface of silicon particles. This indicates that the plasticity of the LPSCl solid electrolyte cannot follow the form change of the interface. However, shell voids in the interface were formed for all directions, but some parts remained in contact area between the silicon particles and the solid electrolyte. The isolation of silicon particles from the solid electrolyte interface is suggested to be one of the factors causing the poor cycle performance because of the lithium ion reaction path is limited. 1) T. Li, J. Y. Yang, S.G. Lu, H. Wang and H. Y. Ding, Rare Metals , 32 , 299-304 (2013). 2) W. Ping, C. Yang, Y. Bao, C. Wang, H. Xie, E. Hitz, J. Cheng, T. Li and L. Hu, Energy Storage Materials , 21 , 246-252 (2019). 3) Y. Sakka, H. Yamashige, A. Watanabe, A. Takeuchi, M. Uesugi, K. Uesugi and Y. Orikasa, J. Mater. Chem. A , 10 , 16602–16609 (2022).

Effect of Defects and Solvents on Silicene Cathode of Nonaqueous Lithium–Oxygen Batteries: A Theoretical Investigation

Li+ Solvation Structure Modification in Chemical Prelithiation Enabling Spatially Homogeneous Sei Toward High Performance Siox Anode

Lithiation of SiO2 in Li-ion Batteries: in Situ Transmission Electron Microscopy Experiments and Theoretical Studies.

Molecular-level insights into the reactivity of siloxane-based electrolytes at a lithium-metal anode.

Adsorption and Mobility of Lithium on Pristine and Stone-Thrower-Wales Defective Silicenes

Probing the Reactivity of the Active Material of a Li-Ion Silicon Anode with Common Battery Solvents

In Situ Spectroscopic Probing of Oxygen Crossover Effects on Solid Electrolyte Interphase in Aprotic Lithium‐Oxygen Batteries

Two-dimensional Siligraphenes As Cathode Catalysts for Nonaqueous Lithium-Oxygen Batteries

Catalytic Mechanism of Oxygen Vacancies in Perovskite Oxides for Lithium‐Sulfur Batteries

(Digital Presentation) Operando X-Ray CT Analysis of Silicon-Solid Electrolyte Mechanical Interface of All-Solid-State Battery

Lithiation and Sodiation of Hydrogenated Silicene: A Density Functional Theory Investigation

Facilitating catalytic activity of indium oxide in lithium-sulfur batteries by controlling oxygen vacancies

Link between anisotropic electrochemistry and surface transformations at single‐crystal silicon electrodes: Implications for lithium‐ion batteries

Interfacial Effects On Lithium Superoxide Disproportionation In Li-O-2 Batteries

Deformation and failure of lithiated Si electrodes of Li-ion batteries

Enhancing Lithium-Sulfur Battery Performance by MXene, Graphene, and Ionic Liquids: A DFT Investigation

Chemical Pre-lithiation of SiO x Anodes with a Weakly Solvating Solution of Polycyclic Aromatic Hydrocarbons for Lithium-Ion Batteries

Atomic Insight into the Lithium Storage and Diffusion Mechanism of SiO2/Al2O3 Electrodes of Lithium Ion Batteries: ReaxFF Reactive Force Field Modeling

Silicene Oxide: a Potential Battery500 Cathode for Sealed Non-Aqueous Lithium–oxygen Batteries

On ways of conversion of silicon dioxide SiO2 in lithium battery systems: a review

Mitigating the Interfacial Degradation in Cathodes for High Performance Oxide-Based Solid-State Lithium Batteries.