Abstract:Intelligent power management system is an important part of the smart grid, in which the non-intrusive load monitoring technology is one of the key technologies. However, most of the load monitoring methods regard this task as a multi-classification problem, thus it is not effective to identify the unknown loads that did not participate in training. In this paper, an adaptive non-intrusive load monitoring method based on feature fusion has been proposed which utilizes both information of harmonic current feature and voltage-current (V-I) trajectory feature. The harmonic current feature is obtained from the high-frequency load sampling data through Fast Fourier Transform (FFT). At the same time, the V-I trajectory feature is obtained by using the pre-trained convolutional autoencoder neural network that was trained for feature extraction on a public dataset. After the feature extraction, the similarity between these two feature vectors and the available feature vectors in the database is calculated by TOPSIS algorithm. Then the load monitoring can be carried out according to the similarity. When the maximum similarity is greater or equal than the set threshold, the load is considered to be one of the existing loads in the database, otherwise, it will be considered as a new type of load, and the load feature database will be updated. The autoencoder model is trained by using the V-I trajectory from the BLUED dataset and the PLAID dataset is used to verify the identification accuracy of the proposed algorithm by comparison with different algorithms. On the PLAID dataset, the identification accuracy can reach above 97%. Finally, on the embedded Linux system with STM32MP1 as the core, some household electrical appliances are used for validation in real house environment. The results show that the proposed method has improved the capability of load identification by using the complementarity of different features. It can be carried out in real time on embedded system and is able to identify the unknown load at the same time.

Non-Intrusive Load Monitoring by Voltage–Current Trajectory Enabled Transfer Learning

An Overview of Non-Intrusive Load Monitoring Based on V-I Trajectory Signature

A residual convolutional neural network with multi-block for appliance recognition in non-intrusive load identification

Non-Intrusive Load Monitoring by Load Trajectory and Multi-Feature Based on DCNN

Non-intrusive load monitoring based on semi-supervised smooth teacher graph learning with voltage–current trajectory

A Few-Shot Learning method for Non-Intrusive Load Monitoring with V-I Trajectory Features

Non-Intrusive Adaptive Load Identification Based on Siamese Network

A Novel Transfer Learning-Based Intelligent Nonintrusive Load-Monitoring With Limited Measurements

Adaptive Non-Intrusive Load Monitoring Based on Feature Fusion

A Learnable Image-Based Load Signature Construction Approach in NILM for Appliances Identification

Non-Intrusive Load Monitoring Using a CNN-LSTM-RF Model Considering Label Correlation and Class-Imbalance

Temporal and Spectral Feature Learning with Two-Stream Convolutional Neural Networks for Appliance Recognition in NILM

Load Identification Based on Attention Semisupervised Curriculum Label Learning With AVME-HT Feature

Nonintrusive Load Monitoring (NILM) Using a Deep Learning Model with a Transformer-Based Attention Mechanism and Temporal Pooling

Non-intrusive Load Monitoring based on Self-supervised Learning

Non-Intrusive Load Identification Based on Retrainable Siamese Network

Transfer Learning for Non-Intrusive Load Monitoring

Unknown appliances detection for non-intrusive load monitoring based on vision transformer with an additional detection head

A non-intrusive load monitoring algorithm based on multiple features and decision fusion

Transfer learning for multi-objective non-intrusive load monitoring in smart building

Improving multi-state appliance classification by SE-DenseNet based on color encoding in non-intrusive load monitoring