Abstract:Here, an anionic surfactant [AOT]- (bis-(2-ethylhexyl) sulfosuccinate)-stabilized H2O/[Omim][PF6] (1-octyl-3-methylimidazolium hexafluorophosphate) microemulsion has been tested for the first time as a medium for the electropolymerization of 3,4-ethylenedioxythiophene (EDOT). To formulate AOT-stabilized [Omim][PF6]-based microemulsions of different water contents, the phase triangle was determined at 35 °C. Measurements of the conductivities of the microemulsions, their solubilization capacities toward EDOT and their catalytic effects on EDOT electrooxidation show that the present [AOT]--stabilized ionic liquid microemulsion is a good medium for EDOT electropolymerization. Studies on the process of the electropolymerization of EDOT in this [Omim][PF6]-based microemulsion indicate that the water content (i.e., microstructure) of the microemulsion medium is an important factor affecting the onset potential and the deposition rate of the PEDOT. The morphology and the doping level of the as-prepared PEDOT are also found to be correlated with the water content of the ionic liquid microemulsion. The microemulsion with higher water content results in a PEDOT with better electroactivity and higher doping levels. FTIR spectra and XPS analysis show that the PEDOT electrosynthesized in the microemulsion is co-doped by both [AOT]- and [PF6]-. Compared with the neat [Omim][PF6], the use of the ionic liquid microemulsions can reduce not only the consumption of the expensive ionic liquid, but also the onset potential for the electrooxidation of EDOT. Moreover, by tuning the water content of the medium, the electropolymerization of PEDOT and its electrochemical properties could be regulated accordingly. Under the identical deposited charge, the PEDOT originated from the high water content microemulsion (50% H2O μE) has a higher specific capacitance (124 F g-1) than that from neat [Omim][PF6] (117 F g-1). It follows that the present ionic liquid microemulsion is a good medium for EDOT electropolymerization. The present study opens up a new route for the green and low-cost electrochemical preparation of high-performance PEDOT.

Electrosynthesis and Characterization of A New Conducting Copolymer from 2 '-Aminomethyl-3,4-ethylenedioxythiophene and 3,4-Ethylenedioxythiophene

Electrosynthesis and Characterization of Aminomethyl Functionalized PEDOT with Electrochromic Property

Electrochromic Properties of Polymers/Copolymers Via Electrochemical Polymerization Based on Star-Shaped Thiophene Derivatives with Different Central Cores

Multielectrochromic Copolymers of 3,4-Ethylenedioxythiophene and Naphthalene Prepared Via Electropolymerization in Boron Trifluoride Diethyl Etherate

Synthesis of New Thiophene Monomer and Its Electrochemical Polymerization

Novel Electrochromic Copolymers Based on Thiophene-Anthracene Derivatives Via Electrochemical Polymerization in Boron Trifluoride Diethyl Etherate

Physical and Electrochemical Properties of Soluble 3,4-Ethylenedioxythiophene (EDOT)-Based Copolymers Synthesized via Direct (Hetero)Arylation Polymerization

Electrochemical Copolymerization Study of O-Toluidine and O-Aminophenol by the Simultaneous Eqcm and in Situ Ftir Spectroelectrochemisty

Photophysical and Electrochemical Properties of Alternating Copolymers Consisting of 3,4-Ethylenedioxythiophene and 4,4′-Diphenylamine/3,6-carbazole

Electropolymerization of EDOT in an anionic surfactant-stabilized hydrophobic ionic liquid-based microemulsion.

Fluorinated Oleophilic Electrochromic Copolymer Based on 3‐(N‐Trifluoroacetamido)thiophene and 3,4‐Ethylenedioxythiophene (EDOT)

Chemical Synthesis of Poly(3,4-Ethylenedioxythiophene)in Three Different Solvents

Electrochemical Copolymerization of Bithiophene and 3, 4- Ethylenedioxythiophene

Electrochemical copolymerization of 3,4-ethylenedioxythiophene and dithienothiophene: influence of feed ratio on electrical, optical and electrochromic properties

Investigation on the Electrochemical Polymerization and Electrochemical Behavior of 3,4-Ethylenedioxy-thiophene in Aqueous Solution

STRUCTURE AND ELECTRIC PROPERTIES OF POLY(3,4-ETHYLENEDIOXYTHIOPHENE) FILMS PREPARED THROUGH MODIFICATION OF LB FILM TEMPLATES

Electrochemical copolymerization of 3-methylthiophene and 3-chlorothiophene

Conductance Investigation of P-Miecs Fabricated by Poly(3,4-Ethylenedioxy Thiophene), Polyacrylic Acid, Polyethylene Oxide, and Lithium-Ion Salt

Preparation and Characterization of Poly(2′-Aminomethyl-3,4-ethylenedioxythiophene) by Chemical Oxidative Polymerization

Fabrication of Poly(3,4‐ethylenedioxythiophene)‐polysaccharide Composites

Effect of EDOT Solvent on Molecular Structures and Properties of PEDOT Synthesized by Liquid Phase Depositional Polymerization