Abstract:The pressure on a tunnel lining is an important issue in shield tunnel design, because it is related to the safety and durability of the lining. There is an increasing need for short (about 1 km) but wide traffic tunnels in parts of China near rivers. In order to satisfy the gradient requirement of the road over such a short distance, the depth of the overburden is inevitably very shallow. The non-uniform distribution of the pressure on the lining of this kind of tunnel may result in damage to the tunnel segments. However, little published research is available on this topic. In this study, in-situ monitoring was carried out to measure the pressure on the lining of a large cross-river shield tunnel (diameter D 11.36 m) with a shallow overburden (0.7 D) in silty-sandy ground. A pad type earth pressure gauges and pore-water pressure gauges were used to measure the pressures on the tunnel lining, including the tail brush pressure, grouting pressure, earth pressure and pore-water pressure. The time history and the distribution of pressures on the lining during tunnel construction and post-construction were obtained. A comparison between the measured values and theoretical values was carried out. This showed that the tail brush pressure had a considerable effect on the segments while the shield machine was passing through. Non-uniform tail brush pressures caused cracking and water leakage in the concrete segments. The maximum pressure induced by the backfill grouting was twice that of the theoretical earth pressure. However, the non-uniformity of the backfill grouting induced pressure was not as great as that induced by the tail brushes. In the silty sandy ground, the earth pressures were generally stable 24 h after segment assembly. The final stable values were close to the total overburden pressure, particularly at the tunnel crown. The pore-water pressure generally was equal to the hydrostatic pressure and accounts for a large proportion of the total earth pressure. (C) 2017 Elsevier Ltd. All rights reserved.

Impact of increased linings on pressure transients induced by a train passing through a tunnel

INTERACTION OF SURROUNDING ROCK OR SOIL AND LINING OF A PRESSURE TUNNEL

Observed response of a shield-driven tunnel to fluctuations in river stage

Long-term nonlinear consolidation of soil around a shield tunnel with partially sealing linings under train loading

Influence of tunnel cross-sectional shape on surface pressure change induced by passing metro trains

Effects of ambient pressure on aerodynamic pressures induced by passing metro trains in tunnels

Study on aerodynamic pressures caused by double-train tracking operation in a metro tunnel

Three-dimensional characteristics of pressure waves induced by high-speed trains passing through tunnels

Variations of Transverse Forces on Nearby Shield Tunnel Caused by Foundation Pits Excavation

Reduction of Pressure Transients of High-Speed Train Passing Through a Tunnel by Cross-Section Increase

Field measurements of aerodynamic pressures induced by suburban rail transit train passing through double-track tunnel with mid-partition wall

Study on Influence Factors and Changing Law of Micro-pressure Waves at Tunnel Portals of High-speed Railways

Response Characteristics of Cross Tunnel Lining under Dynamic Train Load

A novel method of imposing external water pressure to explore the failure behavior of railway tunnel linings

Effect of erosion void on segmental tunnel lining: 2D numerical investigation

Risks of Ear Complaints of Passengers and Drivers While Trains Are Passing Through Tunnels at High Speed: A Numerical Simulation and Experimental Study

Pressures on the Lining of A Large Shield Tunnel with A Small Overburden: A Case Study

Influence of the door opening on the pressure transient caused by the high-speed subway train passing through the double-track tunnel with the mid-partition wall

Aerodynamic Effects of Inclined Portals on the Initial Compression Wave Generated by a High-Speed Train Entering a Tunnel

Experimental and numerical study of the failure mechanism and stability of tunnel linings under different cavity conditions

Response analysis of tunnel lining structure under impact and fire loading