Source analysis of siliceous minerals and uranium in Early Cambrian shales, South China: Significance for shale gas exploration

Tao Jiang,Zhijun Jin,Guangxiang Liu,Quanyou Liu,Bo Gao,Zhongbao Liu,Haikuan Nie,Jianhua Zhao,Ruyue Wang,Tong Zhu,Tao Yang
DOI: https://doi.org/10.1016/j.marpetgeo.2018.11.002
IF: 5.361
2019-01-01
Marine and Petroleum Geology
Abstract:Efficient shale gas exploration in the Early Cambrian shales of southern China requires the identification of favorable target areas. This study used logs for U, Si, Al, and total organic carbon (TOC) from three typical wells to assess a new framework for gas exploration in this area. The excess siliceous mineral content (from a non-terrigenous clastic source) ranged from 20 to 30% in most layers, reaching 50%. Analysis of these excess siliceous minerals using an AlFeMn ternary plot showed that most were probably derived from hydrothermal fluids within the boundary of the Yangtze and Cathaysian plates. Excess siliceous mineral content and uranium content had a good positive correlation, both tending to decrease away from the plate boundary, indicating that both were derived from hydrothermal fluids. Radioactive uranium in hydrothermal fluids can enhance biological productivity, which is conducive to the increased accumulation of sedimentary organic matter. Therefore, shale gas exploration in the Early Cambrian layers of South China should focus on target areas near the plate boundary that have increased uranium levels, moderate maturity, and good preservation conditions.
What problem does this paper attempt to address?