Abstract:Acoustic waves can be used for wireless telemetry as an alternative to situations where electrical or optical penetrators are unsuitable. However, the response of the ultrasonic transducer can be greatly affected by temperature variations, mechanical deformations, misalignment between transducers, and multiple layers in the propagation zone. Therefore, this work sought to quantify such influences on communication between ultrasonic transducers. The experimental measurements were performed at the frequency where power transfer is maximized. Moreover, there were four experimental models, each with its own performed setup. The ultrasonic transducers are attached to both sides of a 6 mm thick stainless-steel plate for configuring just one barrier. Multiple layers of transducers are attached to the outer side of two plates immersed in an acoustic fluid with a 100 mm thick barrier. In both cases, the S21 parameter was used to quantify the influence of the physical barrier because it correlates with the power flow between ports that return after a given excitation. The results showed that when a maximum deformation of 1250 μm/m was applied, the amplitude of the S21 parameter varied around +0.7 dB. Furthermore, increasing the temperature from 30 to 100 °C slightly affected the S21 (+0.8 dB), but the signal decayed quickly for temperatures beyond 100 °C. Additionally, the ultrasonic communication with a multiple layer was found to occur under misalignment with an intersection area of up to 40%. None of the factors evaluated resulted in insufficient power transfer, except for a large misalignment between the transducers. Such results indicate that this type of communication can be a robust alternative, with a minimum alignment of 40% between transducers and electrical penetrators.

Applying Emat For Ultrasonic Communication Through Steel Plates And Pipes

Ultrasonic Energy and Data Transfer through a Metal—Liquid Multi-Layer Channel Enhanced by Automatic Gain and Carrier Control

Characterization Of Emi Effects In Communication Data Link System In The Presence Of High-Power Radar Radiation

Development of Wideband Pulse Compression Surface Wave EMAT

Time Reversal Signal Processing for Ultrasonic Communication through Metal Channels

Flexible Ultrasonic Transducer for RF-Data and Energy Transmission Through the Metal Pipe

Investigation of pipe thickness monitoring using the shear wave EMAT technology with high lift-off distance

A Low-cost Through-metal Communication System for Sensors in Metallic Pipes

The Study on EMAT Applied in Nondestructive Testing of Elevated Temperature Material

Easy-to-operate thickness measurement method for steel plate using bulk-wave EMAT

Research on Transmission Performance of a Surface Acoustic Wave Sensing System Used in Manufacturing Environment Monitoring

Mechanical Strain, Temperature, and Misalignment Effects on Data Communication between Piezoceramic Ultrasonic Transducers

A New Omni-Directional EMAT Using Contra-flexure Coils for Plate Inspection

Software Defined Ultrasonic System for Communication Through Solid Structures

A Lamb Waves Based Ultrasonic System for the Simultaneous Data Communication, Defect Inspection, and Power Transmission

Ultrasonic Wireless Communication Through Metal Barriers

Long-Range EM Communication Underwater With Ultracompact ELF Magneto-Mechanical Antenna

Optimised design of aviation stainless steel sheet SH guided wave focusing PPM EMAT

An Adaptive Noise Reduction Method for High Temperature and Low Voltage Electromagnetic Detection Signals Based on SVMD Combined with ICEEMDAN

Study on the Laser-EMAT Integrated System for Simultaneously Measuring the Width and Depth of Metal Plate

An Optimal Design Method for Improving the Efficiency of Ultrasonic Wireless Power Transmission during Communication