Abstract:Organic photovoltaics (OPVs) have been considered as one of the preliminary candidates for the third-generation solar cells due to their particularly advantages, such as light-weight, low cost, solution processability and mechanical flexibility. In recent years, the power conversion efficiency (PCE) of OPVs has achieved remarkable progress with the development of non-fullerene acceptors (NFAs), which exhibit stronger capability of light absorption and stability than the fullerene acceptors. However, the narrow absorption properties of organic materials still restrict the further breakthrough of the performance of OPVs. It is difficult for the binary heterojunction films to realize the effective wide spectrum utilization of solar energy. Ternary strategy, which consists of one donor and two acceptors or two donors and one acceptor in a bulk-heterojunction, has proven to be an effective and facile way to enhance performances of OPVs. The emergence of new NFAs such as ITIC, IT-4F, Y6 etc. greatly increases the selectivity of acceptors in a ternary system. It is necessary to investigate the compatibility of latest NFA materials and corresponding ternary device performance. In this article, we report a new ternary OPV system with dual NFAs and a polymer donor. The excellent NFA material (Y6), which was first reported in 2019, is used as the third component. Different concentrations of Y6 are introduced into the binary system based on PBDB-T-2F:IT-4F. The compatibility between materials and device performances are investigated through absorption capability of blend films, AFM, water contact angle, GISAXS, and corresponding electrical properties of devices. The 12.48% PCE is achieved from ternary OPVs with PBDB-T:IT-4F as the active layers containing 20wt% Y6 in acceptors, resulting from the enhanced Jsc of 22.09 mA/cm2, Voc of 0.83 V and FF of 68.45%. The origin of the improvement of the ternary OPVs is summarized below. Firstly, an apparently complementary absorption spectrum is obtained through the introduction of Y6, which has a stronger photo harvesting capability in the spectral range from 750 to 950 nm than IT-4F, and higher short current density (Jsc) is observed in the ternary devices than in the binary device. Secondly, a rougher surface of the active layer is observed by increasing the Y6 concentration, which may result in an inferior exciton dissociation and charge transport process, the existence of larger-scaled crystal is proved by the GISAXS technology. Thirdly, the introduced Y6 can help to suppress the bimolecular recombination, which is in favor of the incremental device performance. Approximately 17.85% PCE improvement is obtained in comparison with PBDB-T-2F:IT-4F based binary OPVs.

Förster Resonance Energy Transfer and Charge Transfer Dynamics in Ternary Organic Nanoparticles

Förster Resonance Energy Transfer and Morphology Optimization for High-Performance Ternary Organic Photodetectors

Interfacial Electron Transfer of P3HT/PDI/ZnO Nanocomposite and Its Application in Visible-Light Detection

Broadband photoresponse promoted by interfacial electron transfer in diketopyrrolopyrrole-based compound/ZnO hybrid nanocomposites

Engineering of Interfacial Electron Transfer from Donor-Acceptor Type Organic Semiconductor to Zno Nanorod for Visible-Light Detection

Achieving Efficient Organic Solar Cells and Broadband Photodetectors Via Simple Compositional Tuning of Ternary Blends

High Performing Ternary Solar Cells Through Förster Resonance Energy Transfer Between Nonfullerene Acceptors.

Organic Near‐infrared Photodetectors with Photoconductivity‐enhanced Performance

Enhanced Charge Transfer Between Fullerene and Non-Fullerene Acceptors Enables Highly Efficient Ternary Organic Solar Cells.

Unveiling the Important Role of Non-Fullerene Acceptors Crystallinity on Optimizing Nanomorphology and Charge Transfer in Ternary Organic Solar Cells

Highly Efficient Ternary Solar Cells with Efficient Förster Resonance Energy Transfer for Simultaneously Enhanced Photovoltaic Parameters

Highly Sensitive Panchromatic Ternary Polymer Photodetectors Enabled by Förster Resonance Energy Transfer and Post Solvent Treatment

Comparative Study of a Simple Fluorescent Emitter in Ternary Nonfullerene- and Fullerene-Based Organic Solar Cells: the Impact on Energy Transfer and Vertical Phase Distribution

Highly Efficient Ternary Near-Infrared Organic Photodetectors for Biometric Monitoring

Dual Förster resonance energy transfer and morphology control to boost the power conversion efficiency of all-polymer OPVs

Π–π Stacking Induced High Current Density and Improved Efficiency in Ternary Organic Solar Cells

High-Performance Ternary Organic Photovoltaics Incorporating Small-Molecule Acceptors with an Unfused-Ring Core

Dual Non-Fullerene Acceptors Based High Efficiency Ternary Organic Solar Cells

High‐performance Ternary Organic Solar Cells With Spectral Uniform Photocurrent Generation by Enhanced Förster Resonance Energy Transfer Induced Reverse Hole Transfer

High-Performance Ternary Nonfullerene Polymer Solar Cells with Both Improved Photon Harvesting and Device Stability.

Efficient and 1,8-diiodooctane-free ternary organic solar cells fabricated via nanoscale morphology tuning using small-molecule dye additive