Abstract:The binary perovskite-type compound (1 − x )BiFeO 3 – x BaTiO 3 (BF-BT) is considered as a promising high-temperature lead-free piezoelectric material due to its high Curie temperature ( T C > 400 °C) and better electromechanical properties. In this work, ternary lead-free piezoelectric ceramics with a chemical formula of (0.67 − x )BiFeO3–0.33BaTiO3– x Bi(Zn0.5Ti0.5)O 3 + 1 mol% MnO 2 (where x = 0–0.05) were prepared by the conventional solid-state reaction route. The effects of Bi(Zn 0.5 Ti 0.5 )O 3 introduction on the phase structures and microstructures, piezoelectric and dielectric properties, as well as impedance characteristics of BF-BT ceramics were investigated in detail. Firstly, all the samples synthesized exhibit a pure perovskite structure with the coexistence of rhombohedral ( R ) and tetragonal ( T ) phases, and the T phase content increases with increase in x . A small amount of Bi(Zn 0.5 Ti 0.5 )O 3 ( x ≤ 0.03) that were incorporated into the perovskite lattice of BF-BT can promote the grain growth of ceramics. Secondly, all samples were found with a notable relaxed phase transition behavior, T C of the system decreases with increase in x . The AC impedance spectra of the samples were fitted and analyzed according to the R-CPE equivalent circuit model, the electric impedance of the ceramics at high temperatures was mainly contributed by grain boundaries. Moreover, the dielectric relaxation activation energy of the samples firstly decreases and then increases with increase in x . Finally, the composition with x = 0.02 shows the optimized electrical properties among these samples, including T C = 454 °C, d 33 = 117 pC/N, k p = 23%, tan δ = 0.11, which are mainly benefited from the bismuth content compensation and the substitution of (Zn 0.5 Ti 0.5 ) 3+ for Fe 3+ at B-site reducing the valence change of Fe 3+ in BF-BT.

Large electric‐field‐induced strain and enhanced piezoelectric constant in CuO‐modified BiFeO3‐BaTiO3 ceramics

Enhanced Electric-Field-induced Strain in 0.7bi(1−x)smxfeo3–0.3batio3 Lead-Free Ceramics

Structural Evolution, Electrical Properties and Electric-Field-induced Changes of (0.8− X )pbtio 3 – X BiFeO 3 –0.2bazro 3 System Near the Morphotropic Phase Boundary

Enhanced Ferroelectricity, Piezoelectricity and Ferromagnetism in (ba0.75ca0.25)tio3 Modified BiFeO3 Multiferroic Ceramics

Large electric field-induced strain in BiFeO3-based ceramics by tuning defect dipoles and phase structure

Effects of Bi(Zn0.5Ti0.5)O3 introduction on the structures and electrical properties of BiFeO3–BaTiO3 lead-free piezoelectric ceramics

Low electric field induced large electromechanical properties of BiFeO3-BaTiO3-based ceramics via phase composition modulation

Investigation of BiFeO3-BaTiO3 Lead-Free Piezoelectric Ceramics with Nonstoichiometric Bismuth

Enhanced high-temperature piezoelectric properties of Bi(Zn0.5Ti0.5)O3-modified BiFeO3–BaTiO3 ceramics

Phase transition and electrical properties of Ba 0.7 Ca 0.3 TiO 3- BiFeO 3 ceramics

Enhanced piezoelectric performances induced by the flatten Gibbs free energy of BiFeO3-based ceramics

The development of BiFeO 3 -based ceramics

Origin of large electric-field-induced strain in pseudo-cubic BiFeO3–BaTiO3 ceramics

Quenching and Electrical Current Poling Effect on Improved Ferroelectric and Piezoelectric Properties in BiFeO 3 -Based High-Temperature Piezoceramics

(1-<i>x</i>)(K<sub>0.475</sub>Na<sub>0.475</sub>Li<sub>0.05</sub>)(Nb<sub>0.975</sub>Sb<sub>0.025</sub>)O<sub>3</sub>-<i>x</i>BiFeO3 Lead-Free Piezoelectric Ceramics with CuO Sintering Aid

Lead-Free BiFeO3-BaTiO3 Ceramics with High Curie Temperature: Fine Compositional Tuning Across the Phase Boundary for High Piezoelectric Charge and Strain Coefficients.

The development of BiFeO3-based ceramics

Achieving high Curie temperature and prominent piezoelectric response via site engineering for BiFeO3-BaTiO3 ceramics

High strain in (Bi1/2Na1/2)0.935Ba0.065TiO3–Sr3FeNb2O9 lead-free ceramics with giant piezoresponse

(1-X)(K0.475na0.475li0.05)(Nb0.975sb0.025)O-3-Xbifeo(3) Lead-Free Piezoelectric Ceramics With Cuo Sintering Aid

Enhanced Electric Field-Induced Strain Properties in Lead-Free BF-BT-Based Piezoceramics by Local Structure Inhomogeneity