HVCKEL EIGENVALUES OF RECTANGULAR CLUSTERS

Lu Tianxiong,Jiang Yuansheng
DOI: https://doi.org/10.3866/pku.whxb19880413
1988-01-01
Acta Physico-Chimica Sinica
Abstract:The Huckel eigenvalnes of three dimensional rectangular clusters of arbitary size are explored on concerning not only the nearest but also those second and third neighboring interactions. For better specifying these interactions, three sets of parameters namely (beta(1),beta(2),beta(3)) (eta(1),eta(2),eta(3)) and zeta are introduced which can be illustrated schematically by (4) under tilde.Based on the well-known solution of the linear Backed chain governed by a tri-diagonal matrix A((1)) and the commutability between matrices' A((1))'s of equal dimension, we efficently derive the gonersl solutions for the planar and rectangular clusters respectively which are expressed by Eqa. (11) and (16).The three dimensional solution can be reduced to various special cases previously obtained by Messmer([2]) and Bilek & Skala([3]) but that for the face center rectangular lattice is new due to the introduction of parameters (eta(1),eta(2),eta(3)). The energy levels spread symmetricaly around a in terms of parameters (beta(1),beta(2),beta(3)) and zeta but the antibonding partners would be increased depending on the magnitude of eta's as indicated by (7) under tilde. This means that the second neighbors play a role of destabilization in more or less extent much like the Meddling contribution in ionic crystals. As a consequence, the face center (fc) lattice would be less favorable than the body-center (bc) one for alkali crystals, which seems really the case that most alkali metals are of be lattice except for lithium which is of either lattice form.What is the minimum size of a cluster behaving like a crystal? In other words, when does the discrete energy levels change into continuous bands? By dint of the present results, we try to propose a criterion of maximum energy level separation, 0.02 eV that a finite cluster might behave approximately as a crystal. In order to illustrate the estimation, numerical calculation are given in Table 2.
What problem does this paper attempt to address?