Abstract:Both brushed dc motors and brushless dc motors have a wide range of applications, but mechanical commutating devices have the problem of harmful commutation arcs, and electronic commutating devices increase the cost of control systems. The uncontrolled mechanical–electronic hybrid commutating device passively controls the voltage of the freewheeling commutator segment through the capacitor, but the capacitor, inductor and resistor with fixed parameters in the freewheeling circuit are difficult to apply to the entire operating range. Therefore, this article proposes a controlled mechanical–electronic hybrid commutating device and a position sensorless control method. The mechanical component realizes the conduction mode of 120$^{\circ }$ square waves through brushes and a mechanical commutator. The electronic component actively controls the voltages of the commutator segments through the power electronic switches in the commutation circuit so that the brush and the newly separated commutator segment remain equipotent, and the gap between them does not bear voltage, which is equivalent to operating in the brush-slip ring state and completely solves the problem of sparking and arcing during the commutation process. The controlled hybrid commutating device requires only two switches to obtain the same commutation effect as the electronic commutating device with six switches and does not require a position sensor or control chip, which reduces the system cost. The validity and feasibility of the controlled mechanical–electronic hybrid commutation theory and device are verified by experiments.

A Novel DC Motor Based on Mechanical–Electrical Hybrid Commutation

A Novel Adaptive Commutation Angle Method for Single Phase BLDC Motor

An Arcless Theory of Mechanical–Electronic Hybrid Commutation

Analysis of Armature Circuit of the New DCM

A Novel DC Motor Commutated by Mechanical Commutator and Power Electronic Devices

Steady Performance Analysis on Single-Phase Brushless DC Motor

A Controlled Mechanical–Electronic Hybrid Commutation Theory and Position Sensorless Control

A Low Cost Hybrid Excitation Brushless DC Motor

A Novel PWM Scheme to Eliminate the Diode Freewheeling in the Inactive Phase in BLDC Motor

Motion Control Motor-Brushless DC Motor

Design and Analysis of a Novel Integrated Starter-Generator Based on Brush DC Motor

Practice on the New Generation of DC Motor(New DCM)

A Novel Strategy to Suppress Commutation Torque Ripple in Brushless DC Motor Based on Unitive Formula

A Novel Transverse-Flux Switched-Flux Pm Linear Motor

A Novel Self-Commutating Low-Speed Reluctance Motor for Direct-Drive Applications

A Low-Cost PM Brushless Doubly-Salient Motor

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Bi-directional DC-AC using BLDC motor for electric and hybrid electric vehicles applications with reduced number of switches

New Theory of DC Motor

A Novel Structure of Dual-Stator Hybrid Excitation Synchronous Motor

A Novel Dual Rotor Flux-Bidirectional-Modulation Machine for Hybrid Electrical Vehicles