Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Catalytic Performance of Pd–NiCo2O4/SiO2 in Lean Methane Combustion at Low Temperature

A highly active Pd/H-ZSM-5 catalyst in lean methane combustion prepared <i>via</i> a sol-gel method and treated by reduction-oxidation

Electron transferring with oxygen defects on Ni-promoted Pd/Al 2 O 3 catalysts for low-temperature lean methane combustion

Electron Transferring with Oxygen Defects on Ni-promoted Pd/Al2O3 Catalysts for Low-Temperature Lean Methane Combustion

Catalytic Performance of Novel Hierarchical Porous Flower-Like NiCo2O4 Supported Pd in Lean Methane Oxidation

Uniformly Dispersed Nano Pd-Ni Oxide Supported on Polyporous CeO<sub>2</sub> and Its Application in Methane Conversion of Tail Gas from Dual-Fuel Engine

Incorporating Si into NiO support to facilitate oxygen activation for CH 4 combustion

Superior catalytic combustion of methane over Pd supported on oxygen vacancy-rich NiAl2O4

Durable PdNi/Al2O3 Catalysts with PdO-NiO and PdO-NiAl2O4 Dual Interfaces for Methane Combustion

Oxidation of methane over Pd/mixed oxides for catalytic combustion

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Preparation of Pd/SiO2 Catalysts by a Simple Dry Ball-Milling Method for Lean Methane Oxidation and Probe of the State of Active Pd Species

Facile synthesis of palladium incorporated NiCo2O4 spinel for low temperature methane combustion: Activate lattice oxygen to promote activity

Catalytic combustion of lean methane over MnCo2O4/SiC catalysts: Enhanced activity and sulfur resistance

Oxygen Vacancies Coupled with Surface Silicide Facilitate the CO2 Activation at Near-Room Temperature for Efficient Methane Productivity on Ni-Oxide Supported Pd Nanoparticles

Combustion-impregnation preparation of Ni/SiO2 catalyst with improved low-temperature activity for CO2 methanation

Catalytic Behavior of Flame-Made Pd/TiO2 Nanoparticles in Methane Oxidation at Low Temperatures

Nickel Oxide As an Effective Catalyst for Catalytic Combustion of Methane

Highly active SiO 2 -supported palladium nanoparticles prepared by a modified ammonia evaporation method for lean methane oxidation

Highly active Ni/CeO2/SiO2 catalyst for low-temperature CO2 methanation: Synergistic effect of small Ni particles and optimal amount of CeO2

Cobalt promoted Ni/MgAl2O4 catalyst in lean methane catalytic oxidation