Abstract:ELM mitigation with multi-pulses of SMBI has been demonstrated in EAST tokamak in quasi-steady state over 3 seconds. The ELM frequenc y increasing factor with SMBI is about 5-10. The energy confinement is slightly degraded during the ELM mitigation. Intermittent small scale turbulence, generated by SMBI inside the pedestal r egion, prevents the formation of ELMs, or reduces the amplitude of the ELM, while large scale turbule nc is triggered by the mitigated ELM. The power deposition width ( λq ) is increased by a factor of 2 with SMBI. The peak heat load is reversed from the outer strike point to the striated heat flux ar e with multi-pulses of SMBI, while the total heat on the outer divertor plates remains nearly constant. The heat transferred from the OSP to the SHF increases with SMBI pulse length. A combination of SMBI and LHCD can offer a large possibility for the control of the power deposition on the divertor plates by changing I p, the LHCD power, and the parameters of SMBI including the gas pressure, the pulse length, and the frequency. I) Introduction One of the major challenges for the magnetic fusio n c mmunity is how to extract energy from the core plasma of the fusion reactor w ithout endangering the plasma facing components, in particular the divertor plates. For ITER, in order to not damage the divertor plates, the peak power load on the target plates is limited to 10MW/m in steady condition and 20MW/m in transient condition during Type-I Edge Localize d Modes (ELMs) [1, 2]. How to reduce the power flux density on the divertor plate s is a critical issue. Techniques could be used to reduce the power flux density on the struct u e such as: inclining of the target plate for increasing the effective area; expanding of the fie ld line flux into divertor; power radiation from particles through ionizing collisions and elec tron relaxation. The existing ELM control techniques are the following: Pellet pacing [3], Re sonance Magnetic Perturbation (RMP) [4] and other external perturbation fields [5]. The Sup ersonic Molecular Beam Injection (SMBI) is a new technique for the ELM mitigation. The ELM mitigation with single pulse of SMBI has been firstly achieved in HL-2A [6], then confir med in KSTAR [7]. We report here the experimental results in EAST tokamak showing a very promising and effective technique with SMBI and Lower Hybrid Current Drive (LHCD) for the control of heat deposition on the divertor plates, and the mitigation of large ELMs i n quasi-steady state.

Scenario Development for High Βp Low Torque Plasma with Qmin above 2 and Large-Radius Internal Transport Barrier in DIII-D

1 EX / P 5-24 Observation of a Natural Particle Transport Barrier in HL-2 A Tokamak

Divertor Power Deposition Control and ELM Mitigation with Supersonic Molecular Beam Injection in the EAST Tokamak

Gyrokinetic Simulation of Electromagnetic Instabilities in the High Β P Scenario on EAST

Dependence of the Internal Inductance on the Radial Distance Between the Primary and Secondary X-point Surfaces in the EAST Tokamak

TRANSPORT AND STABILITY IN SUSTAINED HIGH q_min, HIGH β_N DISCHARGES ON DIII-D

Extremum-Seeking-Based Receding-Horizon Optimal Control of Plasma Current Profile in the DIII-D Tokamak

Towards Model-Based Current Profile Control at DIII-D

Discovery of stationary operation of quiescent H-mode plasmas with net-zero neutral beam injection torque and high energy confinement on DIII-D

Predictive multi-channel integrated modeling of a reversed magnetic shear H-mode discharge with internal transport barrier in EAST

Compatibility of divertor detachment and ELM suppression in DIII-D high-βp plasmas with ITER-similar shape

Electron ITB formation in EAST high poloidal beta plasmas under dominant electron heating

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Dynamics of Electron Internal Transport Barrier Formation at the H–L Transition on EAST

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Simultaneous access to high normalized current, pressure, density, and confinement in strongly-shaped diverted negative triangularity plasmas

Broadening of the Divertor Heat Flux Profile in High Confinement Tokamak Fusion Plasmas with Edge Pedestals Limited by Turbulence in DIII-D

Integrated ELM and divertor power flux control using RMPs with low input torque in EAST in support of the ITER research plan

Quiescent H-mode operation using torque from non-axisymmetric, non-resonant magnetic fields

T i /T e effects on transport in EAST low q 95 plasmas