Abstract:In recent years, piezoelectric actuators, represented by inertial and inchworm actuators, have been widely applied because of their high accuracy and excellent responsiveness. Despite the development of various piezoelectric actuators, there remain some flaws in this technology. The sticking point is that the piezoelectric actuators based on the friction driving principle are prone to unwanted backward motion when outputting stepping motion. It is thus urgent to explore solutions from the perspectives of principle and structure. In this paper, a clamping-drive alternating operation piezoelectric actuator is proposed, the two feet of which are driven by two piezoelectric stacks, respectively. Due to double-foot alternate drive guide movement, backward movement is prevented in theory. By adopting the double-layer stator structure, integrated processing and assembly are facilitated. Meanwhile, a double flexible hinge mechanism is installed in the stator to prevent the drive foot from being overturned due to ineffectiveness and premature wear. In addition, the stator is equipped with the corresponding preload mechanism and clamping device. After the cycle action mechanism of one cycle and four steps is expounded, a model is established in this study to further demonstrate the principle. With the prototype produced, a series of experiments are performed. In addition, the amplitude of actuation of the stator is tested through amplitude experiment. The performance of the stator is evaluated by conducting experiments in the alternating step and single step actuation modes. Finally, the test results are analyzed to conclude that the actuator operating in either of these two modes can meet the practical needs of macro and micro actuation.

Design and Driving Characteristics of a Novel ‘pusher’ Type Piezoelectric Actuator

Design and Experimental Study of a Stepping Piezoelectric Actuator with Large Stroke and High Speed

Development and test of a high speed pusher-type inchworm piezoelectric actuator with asymmetric driving and clamping configuration

A Novel Stick–Slip Piezoelectric Actuator Based on a Triangular Compliant Driving Mechanism

A Gravity-Assisted Piezoelectric Inertial Actuator for Bidirectional Smooth Drives by Single Excitation Source

Design and Experiment of a Clamping-Drive Alternating Operation Piezoelectric Actuator

Design, analysis and experimental performance of a stepping type piezoelectric linear actuator based on compliant foot driving

Design and experimental verification of a bolt-clamped piezoelectric actuator based on clamping and driving mechanism

A Multi-Mode Self-Centering Piezo Actuator: Design, Analysis and Its Application in Full-Stroke Microscopic Imaging

Design and Experiments of a Miniature Piezoelectric Actuator Using a Multilayer PZT Bimorph

Design and performance of a compact stick-slip type piezoelectric actuator based on right triangle flexible stator

Experiments and Study of a Low-Frequency, High-Speed Bi-Directional Piezoelectric Stick-Slip Actuator

Achieving Smooth Motion for Piezoelectric Stick–Slip Actuator With the Inertial Block Structure

Design, simulation, and motion characteristics of a novel impact piezoelectric actuator using double statorsstators

A three-degree-of-freedom piezoelectric actuator with sandwich structure: Design, modeling, and experiment

A piezoelectric inertial actuator operating with elliptical drive and stick-slip drive modes

A Single-Clamp Inchworm Actuator with Two Piezoelectric Stacks

Structural Design and Experimental Research of a Novel Piezoelectric Actuator

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Design and Development of a Piezoelectric Linear Actuator for Smart Structures

A Novel Stick-Slip Type Rotary Piezoelectric Actuator