Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Control-oriented Modeling and Analysis of Direct Energy Balance in Coal-Fired Boiler-Turbine Unit

DEB-oriented Modelling and Control of Coal-Fired Power Plant

Direct energy balance based active disturbance rejection control for coal-fired power plant.

Optimization control of a 330 MW drum boiler unit based on DMC algorithm and DEB strategy

Physics-informed Energy-Balanced Modeling and Active Disturbance Rejection Control for Circulating Fluidized Bed Units

Development of a Three-Term MPC and Its Application to an Ultra-Supercritical Coal Fired Power Plant

Modeling of drum boiler-turbine unit and the model-based coordinated control strategy

Modelica-based heating surface modelling and dynamic exergy analysis of 300 MW power plant boiler

Decentralized Nonlinear Control of 300mwe Circulating Fluidized Boiler Power Unit

A dynamic mathematical model used for controller design of a supercritical once-through boiler-turbine unit in all load conditions

Two-timescale Nonlinear Model Predictive Control for Flexible Operation of Coal-Fired Power Plant with Post Combustion CO2 2 Capture System

Dynamic performance analysis and control strategy optimization for supercritical coal-fired boiler: A dynamic simulation

Modelling and control of pulverizing system considering coal moisture

Design of the PID Controller for Circulating Fluidized Bed Boiler Combustion System

Dynamic Model for Subcritical Circulating Fluidized Bed Boiler-Turbine Units Operated in a Wide-Load Range

Dynamic modeling and control for pulverized-coal-fired oxy-combustion boiler island

STUDY ON COORDINATED CONTROL SYSTEM OF UNITS EQUIPPED WITH CFB BOILER

The Facilitation of a Sustainable Power System: A Practice from Data-Driven Enhanced Boiler Control

Dynamic characteristics and control method of the solar-coal energy complementary system

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Decentralized PID Controllers Tuning Based on Desired Dynamic Equations