Abstract:A spray reactor in which the liquid phase containing dissolved p-xylene (pX) and the catalyst is dispersed as fine droplets by a nozzle into a continuous vapor phase containing the oxidant (O2) is shown to produce high-purity terephthalic acid (TPA) with less than 25ppm 4-carboxybenzaldehyde (4-CBA) in the solid TPA product. In sharp contrast, the solid TPA product obtained from a conventional stirred reactor similar to the configuration used in the conventional Mid-Century (MC) process contains nearly 1000ppm 4-CBA even though the reactor is operated at similar pressure and temperature (15bar and 200°C) but with the gas phase dispersed into the liquid phase. The dramatic improvement in TPA product quality during spray reactor operation is attributed to two main factors: the alleviation of interphase gas–liquid mass transfer limitations that facilitates more complete oxidation of the pX and the intermediate oxidation products to TPA, and reduced backmixing that enhances the oxidation rates. Theoretical calculations show that the time constants for O2 diffusion in typical spray droplets (50μm diameter) is 1–2 orders of magnitude lower than the kinetic rate constant confirming complete O2 penetration and saturation of the droplets. Further, the usage of CO2 as an inert gas and the dominance of acetic acid (>50mol.%) in the vapor phase under reaction conditions create an environment that falls outside of the flammability envelope. Mathematical modeling of the stirred reactor using MC process conditions accurately predicts the steady state temperatures observed in industrial reactors. The model also clearly divulges that the cooling provided by partial evaporation of the acetic acid solvent is vital to maintain stable steady state operation. By eliminating the need for a hydrogenation step, the spray reactor has the potential to not only reduce capital and operating costs but also provide environmental benefits.

Direct Preparing O-toluic Acid from O-xylene by Air Oxidation in Liquid Phase

Kinetics of P-Xylene Liquid-Phase Catalytic Oxidation to Terephthalic Acid

Progress in the Research and Development of P-Xylene Liquid Phase Oxidation Process

Modeling of P-Xyoene Oxidation Reactor-Condenser

Optimum Ratio Of Co/Mn In The Liquid-Phase Catalytic Oxidation Of P-Xylene To Terephthalic Acid

Upgrading Phenolic Compounds and Bio-Oil Through Hydrodeoxygenation Using Highly Dispersed Pt/TiO2 Catalyst

Effects of Process Conditions on Products Distribution of Cyclohexane Non-Catalytic Oxidation in Microcapillary

Preparation of Benzaldehyde by Aerobic Liquid-Phase Oxidation of Toluene with Co(acac)2

Simulation and Optimization in the Process of Toluene Liquid-Phase Catalytic Oxidation

Selective liquid phase oxidation of toluene with air

Mild Oxidation of Toluene to Benzaldehyde by Air

Mixed Oxides FeVOx for Selective Oxidation of Octanol to Octanal under Solvent‐free Condition

Highly Selective Oxidation of Toluene to Benzaldehyde in Alkaline Systems

Modeling, simulation and analysis of the liquid-phase catalytic oxidation of toluene

Kinetics of the Liquid-Phase Catalytic Oxidation of Toluene to Benzoic Acid by Air

Toluene Oxyfunctionalization with Air over Metalloporphyrins and Reaction Condition Optimization

A spray reactor concept for catalytic oxidation of p-xylene to produce high-purity terephthalic acid

Mild, Solvent-Free Oxidation of Toluene and Subsituted Toluenes to Their Benzoic Acids Using Carboxylic Acid-Promoted Heterogeneous Catalysis

Synthesis of p-tert-butylbenzoic Acid from Catalytic Oxidation of p-tert-butyltoluene

Partial Oxidation of Toluene in CH3COOH by H2O2 in the Presence of VO (acac)2 Catalyst

Catalytic performance of Co(acac)_2 catalyst for liquid-phase oxidation of toluene by air