Compressive Behavior of Concrete-Filled FRP Tubes with FRP Solid Waste As Recycled Aggregates: Experimental Study and Analytical Modelling
Bing Zhang,Jiaming Sun,Sumei Zhang,Chong Zhou,Zhihong Fan,Yunhao Yan,Guan Lin
DOI: https://doi.org/10.1016/j.jobe.2024.110297
IF: 7.144
2024-01-01
Journal of Building Engineering
Abstract:The disposal and recycling of FRP (Fiber-Reinforced Polymer) solid waste pose significant challenges globally, with a recycling rate of less than 10%. Current methods of handling FRP solid waste (FSW), including landfill disposal, incineration, chemical treatment, and thermal cracking, face limitations in achieving large-scale recycling and resource utilization. In civil engineering, FRP is widely employed for retrofitting structures and holds promise for new constructions. A new approach has emerged for recycling FSW by using it as aggregates in concrete, offering lower costs and reduced environmental impact. Research on using FSW aggregates in plain concrete shows that optimizing replacement ratios and aggregate shapes can enhance split tensile strength and toughness without significantly lowering compressive strength. To further improve the mechanical performance, this study investigated concrete-filled filament-wound FRP tubes with FSW aggregates (FSW-CFFTs) under axial compression. 35 specimens were tested to evaluate the influence of granular FSW aggregates (i.e., replacement ratio = 0%, 20%, 40%, 60%, and 80%) and FRP thickness (i.e., 0mm, 3mm, and 5mm) on their axial compression behavior. The experimental study revealed that: incorporation of FSW aggregates in unconfined concrete cylinders led to a notable decrease in Young's modulus and compressive strength, while concurrently increasing the peak compressive strain; as the replacement ratio of FSW aggregates increased, there was a tendency for the peak stress of FSW-CFFTs to decrease, while their ultimate axial strain tended to increase; compared FSW-CFFTs with unconfined concrete cylinders, the FRP confinement helped to mitigate the reduction ratio in axial compressive strength induced by the inclusion of FSW aggregates in the concrete, particularly at higher FSW aggregate replacement ratios; specimens with a thicker FRP tube exhibited higher secondary stiffness, along with higher strength and larger ultimate compressive strain. The modeling work indicated that accurately predicting axial stress-strain curves requires consideration of the bi-axial stress state of filament-wound FRP tubes.