Abstract:Traditional electrochemical workstations are costly, complex, bulky, and primarily used in laboratories. This study develops a reliable, practical, and cost-effective portable wireless potentiostat to achieve real-time detection on-site and overcome the limitations of traditional electrochemical workstations. The system employs a general-purpose microcontroller unit (MCU), a dual-mode Bluetooth module and cost-effective multi-analog-to-digital converter (multi-ADC) to achieve differential sampling of the LMP91000. The system is equipped with buttons and OLEDs, enabling connection to mobile phones and computers for in-depth data analysis or independent operation. The system was successfully tested with [Fe(CN)6]3-, C6H12O6, and C3H6O3 solutions at concentrations ranging from 0 to 20 mM. The goodness-of-fit (R2) values are 0.984, 0.996, and 0.998, respectively. The average relative standard deviation of the three blank solutions is approximately 3.22%. The detection limits measured (0.003, 0.009, and 0.005 mM) are all lower than the minimum detection concentration (0.2, 0.1, and 0.1 mM). The coefficient of variation for repetitive experiments is less than 5.53%. The device accurately executed chronoamperometry (applied voltage range is ± 1.2 V, current range is ± 882 μA, accuracy is ± 1 %) with high sensitivity and good repeatability. Based on this circuit, a lactic acid detector and a urine glucose detector were developed, which work stably and support long-term operation, proving the stability and reliability of the circuit. Compared to commercial electrochemical workstations, PWES offers remarkable advantages in cost (< $6.4), size (41.5 mm × 76.5 mm), and practicality, making it suitable for a range of applications, including biomedical analysis, food safety, environmental monitoring, and smart wearables.

A Current-Mode ΣΔ AD Based Integrated Potentiostat

An Oscillator Based Potentiostat with Switch-cap Feedback for Current Sensing Applications

A Low Power Potentiostat for Implantable Glucose Sensor Tag

A Bidirectional Current-Mirror Based Potentiostat Using a Slice-Based Class-AB Amplifier

Miniaturized FDDA and CMOS Based Potentiostat for Bio-Applications

A CMOS Detection Chip for Amperometric Sensors with Chopper Stabilized Incremental △∑ ADC

Design of a 68 Db Input Dynamic Range Potentiostat for Electrochemical Biosensing

Design of novel wide-range precision potentiostat with low power dissipation

CMOS Potentiostat for Chemical Sensing Applications

A Programmable Low Power Current Source for Bioimpedance Measurement: Towards a Wearable Personalized Health Assistant.

A portable multi-channel potentiostat for real-time amperometric measurement of multi-electrode sensor arrays

Current Mirror Improved Potentiostat (CMIPot) for a Three Electrode Electrochemical Cell

A Dual-Channel Wide Input Range Interface Circuit for Electrochemical Amperometric Sensors

A Cmos Analog Front-End Chip for Amperometric Electrochemical Sensors

Low-Noise and Process Variation-Tolerant Readout Circuit for Electrochemical Sensors

Design of CMOS potentiostat based on microarray biosensor

A high dynamic range analog-front-end IC for electrochemical amperometric and voltammetric sensors

Reliable Remote-Monitoring Electrochemical Potentiostat for Glucose Measurements

A Reliable, Practical and Cost-Effective Portable Wireless Potentiostat for Mobile Chemical Sensing and Biosensing

A 1.2 V 600 Nw 12-Bit 2 Ks/s Incremental ADC for Biosensor Application

HunStat – a Simple and Low-Cost Potentiostat for Analytical and Educational Purposes