Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

$$\hbox {Mn}_{3}\hbox {O}_{4}$$ Nanosheet and GNS–$$\hbox {Mn}_{3}\hbox {O}_{4}$$ Composite as High-Performance Anode Materials for Lithium-Ion Batteries

Mn_3O_4 Nanosheet and GNS– Mn_3O_4 Composite as High-Performance Anode Materials for Lithium-Ion Batteries

Mn0.5Co2.5O4 Nanofibers Intercalated into Graphene Frameworks with Mesoporous Structure for Batteries and Supercapacitors

MnFe2O4-graphene nanocomposites with enhanced performances as anode materials for Li-ion batteries.

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

Design and Synthesis of the Composites of Multiporous NiMnO3 Micro-Nano Structure Spheres and Graphene with Alleviated Side Reaction and Enhanced Performances As Anode Materials for Lithium Ion Batteries

3D-Hierarchical NiO–graphene Nanosheet Composites As Anodes for Lithium Ion Batteries with Improved Reversible Capacity and Cycle Stability

Mn3O4 nanoparticles embedded in 3D reduced graphene oxide network as anode for high-performance lithium ion batteries

High-performance lithium-ion battery anodes based on Mn3O4/nitrogen-doped porous carbon hybrid structures

Mn3O4 nano-octahedrons embedded in nitrogen-doped graphene oxide as potent anode material for lithium-ion batteries

Lignin-Based Mesoporous Hollow Carbon @ MnO2 Nanosphere Composite as an Anodic Material for Lithium-Ion Batteries

MnO nanoparticles anchored on graphene nanosheets via in situ carbothermal reduction as high-performance anode materials for lithium-ion batteries

Graphene-encapsulated Li2MnTi3O8 Nanoparticles As a High Rate Anode Material for Lithium-Ion Batteries

Facile synthesis of α-MnO2/graphene nanocomposites and their high performance as lithium-ion battery anode

Design of pseudocapacitance and amorphization Co-enhanced Mn3O4/graphene sheets nanocomposites for high-performance lithium storage

A simplified electrophoretic deposition route for sandwiched structure-based Mn3O4/G composite electrodes as high-capacity anodes for lithium-ion batteries

Three-dimensional cross-linked MnO/Sb hybrid nanowires co-embedded nitrogen-doped carbon tubes as high-performance anode materials for lithium-ion batteries

Hierarchical MnV2O4 Double-Layer Hollow Sandwich Nanosheets Confined by N-doped Carbon Layer As Anode for High Performance Lithium-Ion Batteries.

Lignin-Based Mesoporous Hollow Carbon<i>@</i>MnO<sub>2</sub> Nanosphere Composite as an Anodic Material for Lithium-Ion Batteries

Mn3O4 Nanotubes Encapsulated by Porous Graphene Sheets with Enhanced Electrochemical Properties for Lithium/sodium-Ion Batteries

Development of Monodispersed MnCO3/graphene Nanosheet Composite As Anode for Lithium-Ion Battery by Hydrothermal Synthesis