Abstract:In this paper, an exploration of the practical thermodynamic performance limits of the organic Rankine cycle (ORC) under working fluid and cycle parameter restrictions is presented. These performance limits are more realistic benchmarks for the thermodynamic cycle than the efficiency of the Carnot cycle. Subcritical ORC configuration with four typical case studies that are related to temperature ranging from 373.15 to 673.15 K is taken into account. The ORC is defined by its cycle parameters and working fluid characteristic properties. The cycle parameters involve evaporation temperature ( T eva ), condensation temperature ( T con ) and superheat degree (Δ T sup ), while the working fluids are represented by the characteristic properties including critical temperature ( T c ), critical pressure ( p c ), acentric factor ( ω ), and molar ideal gas isobaric heat capacity based on the principle of corresponding states. Subsequently, Pareto optimum solutions for obtained hypothetical working fluids and cycle parameters are achieved using multi-objective optimization method with the consideration of both thermal efficiency ( η th ) and volumetric power output (VPO). Finally, sensitivity analysis of the working fluid characteristic properties is conducted, and the second law of thermodynamics analysis, especially the applicability of entropy generation minimization, is performed. The results show that the current commonly used working fluids are widely scattered below the Pareto front that represents the tradeoff between η th and VPO for obtained hypothetical fluids. T eva and T con are the most dominant cycle parameters, while T c and ω tend to be the most dominant characteristic property parameters. The entropy generation minimization does not give the same optimal results.

Elman and back propagation neural networks based working fluid side energy level analysis of shell-and-tube evaporator in organic Rankine cycle (ORC) system

Simultaneous Optimization of a Heat Exchanger Network and Operating Conditions of Organic Rankine Cycle

Parametric Study on Dynamic Behaviours of Basic Organic Rankine Cycle Recovering Waste Heat with Thermal Power Fluctuations

Analysis of a 1 Kw Organic Rankine Cycle Using a Scroll Expander for Engine Coolant and Exhaust Heat Recovery

Optimization of Organic Rankine Cycle Involving Operating Conditions and Work Fluids and Heat Integration

Comparison study of Trilateral Rankine Cycle, Organic Flash Cycle and basic Organic Rankine Cycle for low grade heat recovery

Experimental Investigations on Dynamic Performance of Organic Rankine Cycle Integrated with Latent Thermal Energy Storage under Transient Engine Conditions

Comparative Investigations on Dynamic Characteristics of Basic ORC and Cascaded LTES-ORC under Transient Heat Sources

Analysis of a Combined Trilateral Cycle - Organic Rankine Cycle (TLC-ORC) System for Waste Heat Recovery

Optimizing Waste Heat Recovery with Organic Rankine Cycles: A Novel Graphical Approach Based on Exergy-Enthalpy Diagrams

Characterization analysis of dynamic behavior of basic ORC under fluctuating heat source

Organic Rankine cycle performance evaluation and thermoeconomic assessment with various applications part I: Energy and exergy performance evaluation

Energy, Exergy, Economic Performance Investigation and Multi-Objective Optimization of Reversible Heat Pump-Organic Rankine Cycle Integrating with Thermal Energy Storage

3D numerical analysis of exhaust flow inside a fin-and-tube evaporator used in engine waste heat recovery

Modeling of Finned-Tube Evaporator Using Neural Network and Response Surface Methodology

Cost-effectiveness Performance Analysis of Organic Rankine Cycle for Low Grade Heat Utilization Coupling with Operation Condition

Energetic and Exergetic Investigation of an Organic Rankine Cycle at Different Heat Source Temperatures

Efficiency and optimal performance evaluation of organic Rankine cycle for low grade waste heat power generation

Analysis of the Thermodynamic Performance Limits of the Organic Rankine Cycle in Low and Medium Temperature Heat Source Applications

Operation characteristics and performance prediction of a 3 kW organic Rankine cycle (ORC) with automatic control system based on machine learning methodology

Correlation analysis based multi-parameter optimization of the organic Rankine cycle for medium- and high-temperature waste heat recovery