Abstract:Geosynthetic-reinforced soil (GRS) retaining walls have been widely adopted in engineering practice based on the development of several design methods. However, the temperature effect, which was proved to be an important influencing factor of retaining wall performance, was not considered in the existing design methods. This study investigates the temperature distributions of a (GRS) wall subjected to freeze–thaw (FT) cycles using (1) a lab-scale physical model test within a custom-made temperature-controlled tank; and (2) a commercial finite-element computer program for conducting numerical modeling. The numerical model was first validated using the lab-scale model test data obtained in this study, and then a full-scale numerical model was created for achieving an in-depth understanding of the temperature distribution behaviors of a real GRS wall subjected to FT cycles. Both model test and numerical results demonstrate that (1) the periodic variation of the ambient temperature during the FT process induces a temperature fluctuation in a sinusoidal shape in the soil, and the temperature distributions of the soil are distinctly related to its location inside the GRS wall; (2) the soil temperature in zones with a distance of 2.0 m to the exposed boundaries (i.e., back of facing panels and road pavement) of the GRS wall is more sensitive to the variation of the ambient temperature. Also, the temperature amplitudes in these regions during each FT cycle are greater than those in the zones far away from the exposed boundaries of the GRS wall; and (3) the frost depth in the vertical direction or frost thickness in the horizontal direction increases constantly with a decrease of the ambient temperature lower than 0°C, and vice versa. The maximum frost depth or thickness behind the GRS wall is lagged to the lowest ambient temperature and decreases with the increase of the distance to the exposed boundaries. In addition, a mathematical model was proposed for predicting the soil temperature amplitudes at different locations inside the GRS wall.

Influence of toe condition on mechanical response of rigid-faced GRS walls

Theoretical Elastoplastic Analysis for Foundations with Geosynthetic-Encased Columns

Impact of Geogrid on Cross-Anisotropy and Permanent Deformation of Unbound Granular Materials

Analysis Of Active Earth Pressure On Rigid Retaining Walls Considering Soil Arching

Seismic effects on reinforcement load and lateral deformation of geosynthetic-reinforced soil walls

Effect of facing stiffness on GRS walls under surcharge loading-unloading

Analytical Method for the Deformation-Based Design of Retaining Walls in Asymmetric Excavation

An Analytical Method for Predicting Load Acting on Geosynthetic Overlying Voids

Earth Pressure Against Rigid Retaining Wall Rotating about Top

Load-Deformation Behavior of Geosynthetic-Reinforced Retaining Walls with Limited Fill Space Under Static Footing Loading

Design Theory and Method of Geo-Synthetic Reinforced Soil Retaining Wall Combined with a Gravity Retaining Wall or Full Height Rigid Facing

Global Buckling Design of Multi-Celled CFST Walls with Four Simply-Supported Edges

Analyzing the Reinforcement Loads of Geosynthetic-Reinforced Soil Walls Subject to Seismic Loading During the Service Life

Mechanical Behavior of Geogrid Flexible Reinforced Soil Wall Subjected to Dynamic Load

Effects of Backfill Constitutive Behavior and Soil–Geotextile Interface Properties on Deformations of Geosynthetic-Reinforced Soil Piers under Static Axial Loading

Model test and numerical analysis on long-term mechanical properties of stepped reinforced retaining wall

Long-term Behavior of GRS Retaining Walls with Marginal Backfill Soils

Temperature Distributions in Geogrid-Reinforced Soil Retaining Walls Subjected to Seasonal Freeze–Thaw Cycles

Experimental investigation of a reinforced soil retaining wall with a flexible geogrid-wrapped ecological bag facing

Active Earth Pressure against Inverted T-Type Retaining Walls under Translation Mode

Evaluation of Prediction Methods for Lateral Deformation of Grs Walls and Abutments