Abstract:Voltage source inverter is commonly used as the interface to connect the renewable energy source and the power grid. In order to improve the performance of renewable energy system, the topology and control method of the inverter system need to be analyzed. In this paper, a single-phase hybrid cascaded inverter is proposed. It is based on two kinds of power devices - MOSFET and IGBT. The cascaded inverter consists of three H-bridges. The DC voltage of each H-bridge meets the proportional relationship of 1:2:4 and the three modules are connected in series at the AC side. The low voltage bridge is composed of MOSFETs, while the medium and high voltage bridges are composed of IGBTs. This hybrid cascaded inverter can output at most 15 voltage levels at the AC side with rather low switching frequency. At the same time, it can fully exhibit the advantages of different power devices and make the inverter operation flexible. Voltage gradational and PWM carrier modulation methods are adopted in the paper. It is shown that the conversion efficiency reaches up to 98% and the output THD is less than 5% (meets requirement of the IEEE standards). Meanwhile, with different combination of switching states, the distribution of input active power in each H-bridge can be adjusted. As a result, for renewable energy system, larger control freedom is provided and the need of power balance is satisfied. The validity of the inverter system is tested by both simulation and experiment.

Research on Novel Hybrid Multilevel Inverter with Cascaded H‐bridges at Alternating Current Side for High‐voltage Direct Current Transmission

Cascaded Half-Bridge Multilevel Inverter with Reduced Number of Power Switches

A Novel Hybrid Full-Bridge Inverter for Ultra-High Frequency Induction Heating Applications

A Novel Modulation Scheme and a DC-Link Voltage Balancing Control Strategy for T-Type H-Bridge Cascaded Multilevel Converters

A Novel Boost Cascaded Multilevel Inverter

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

Cascaded H7 Current Source Converter Based Power Transmission System And Fault Analysis

Performance Evaluation of a Three- Phase Five-Level Quasi-Z-Source Cascaded H-Bridge for Grid-Connected Applications

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter

Investigation Of Control Method For A New Hybrid Cascaded Multilevel Inverter

A Hybrid ZVS Full-Bridge Converter with Transformer Winding Series-Parallel Auto Regulated Current Doubler Rectifier

Improved Cascaded H-Bridge Multilevel Inverters with Voltage-Boosting Capability

Research on topology of hybrid diode-clamping multilevel voltage inverter

A novel transformerless cascaded multilevel converter topology

Investigation of Control Method for a Hybrid Cascaded Multilevel Inverter

High-Performance Control Strategies and Applications of a New Hybrid Cascaded Multilevel Inverter

A Modular Multilevel Converter with Boosting, Self-Balancing, and Scaling Capabilities for High- Voltage Transformerless PV Applications

A Monopolar Symmetrical Hybrid Cascaded DC/DC Converter for HVDC Interconnections

High Performance Hybrid Cascaded Inverter for Renewable Energy System

A Multilevel DC-Link Converter for VSC-HVDC Application

Research of Multilevel Converters on HEV