Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

A New Model for Capturing Void Ratio-Dependent Unfrozen Water Characteristics Curves

An Unfrozen Water Retention Curve for Capturing Soil Density and Specific Surface Effects

A soil freezing characteristic curve model for capturing void ratio and specific surface area effects

Influences Affecting the Soil-Water Characteristic Curve

A mathematic model for the soil freezing characteristic curve: the roles of adsorption and capillarity

A Theoretical Model of Soil Freezing Characteristic Curve Considering the Freezing of Adsorbed Water and Capillary Water

Modeling the Unfrozen Water Content of Frozen Soil Based on the Absorption Effects of Clay Surfaces

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Parameterization of soil freezing characteristic curve for unsaturated soils

The Prediction of the Soil Freezing Characteristic Curve Using the Soil Water Characteristic Curve

A fractal-based soil - Water characteristic curve model for unsaturated soils

Unified Soil Freezing Characteristic for Variably‐Saturated Saline Soils

Predicting the soil freezing characteristic from the particle size distribution based on micro‐pore space geometry

A Theoretical Model of the Soil Freezing Characteristic Curve for Saline Soil

A Unified Thermo-Mechanical Bounding Surface Model for Saturated Clay and Sand

Analytical model to predict unfrozen water content based on the probability of ice formation in soils

Premelting Theory‐Based Mechanism for Water Freezing in Saline Soil

Study on soil freezing characteristic curve during a freezing-thawing process

Characteristics of matric suction in unequal sized quartz silt during horizontal freezing