Abstract:Abstract The main aim of this study is to develop a mathematical size-dependent vehicle cabin model for particulate matter concentration including PM 2.5 (particles of aerodynamic diameter less than 2.5 μm) and UFPs (ultrafine particles of aerodynamic diameter less than 100 nm), as well as CO 2 concentration. The ventilation airflow rate and cabin volume parameters are defined from a previously developed vehicle model for climate system design. The model simulates different filter statuses, application of pre-ionization, different airflow rates and recirculation degrees. Both particle mass and count concentration within 10–2530 nm are simulated. Parameters in the model are defined from either available component test data (for example filter efficiencies) or assumptions from corresponding studies (for example particle infiltration and deposition rates). To validate the model, road measurements of particle and CO 2 concentrations outside two vehicles were used as model inputs. The simulated inside PM 2.5 , UFP and CO 2 concentration were compared with the inside measurements. Generally, the simulation agrees well with measured data (Person’s r 0.89–0.92), and the simulation of aged filter with ionization is showing higher deviation than others. The simulation using medium airflows agrees better than the simulation using other airflows, both lower and higher. The reason for this may be that the filter efficiency data used in the model were obtained at airflows close to the medium airflow. When all size bins are compared, the sizes of 100–300 nm were slightly overestimated. The results indicated that among others, expanded filter efficiency data as a function of filter ageing and airflow rate would possibly enhance the simulation accuracy. An initial application sample study on recirculation degrees presents the model’s possible application in developing advanced climate control strategies.

Simulation Research on Particulate Matter Filtration of a HVAC Vehicle

Size-resolved simulation of particulate matters and CO2 concentration in passenger vehicle cabins

Numerical Simulation on Flow Characteristics of PM2.5 in the Indoor Environment

Simulation Study of a Novel Cylindrical Micro-Electrostatic Particulate Air Filter with High Filtration Efficiency and Low Resistance

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

Numerical Simulation on PM2.5 Filtering by Fibrous Assembly

Simulation Study on Effects of Purifier Positions on Formaldehyde Removal under the Condition of Vehicle Air Supply

Simulation of aerodynamic noise from centrifugal fan of HVAC in automobile

Simulation and test of flow process in air filter

Simulation of Particles Diffusion Characteristics in the Ventilation Duct of the Air Conditioning System

Design and Optimization of Automotive Air Conditioning Duct Based on CFD Algorithm

Performance of Electret Filters for Use in a Heating, Ventilation and Air Conditioning System and an Automotive Cabin against Combustion and NaCl Particles

Investigating the filtration performance and service life of vehicle cabin air filters in China

Characterizing in-cabin air quality and vehicular air filtering performance for passenger cars in China

The mechanism of low-speed steady substitution flow to clean the indoor particulate matter

On-road quantification of the key characteristics of automobile HVAC systems in relation to in-cabin submicrometer particle pollution

An Indoor Airflow Simulation And Airborne Dust Concentration Analysis

Numerical Research on the Filter Performance of Pm2.5 on the Micro-Scale of Fibrous Assembly

Simulation Research of Air Quality Control System of New Airliner Cabin

Simulation of indoor cigarette smoke particles in a ventilated room

Ventilation, Indoor Particle Filtration, and Energy Consumption of an Apartment in Northern China