Abstract:<p>Acoustic emission (AE) event location plays an important role in structural safety assessments. However, accurately locating an AE event is usually difficult, especially for a small structure. Interestingly, a pencil-lead break (PLB) experiment shows that the P-wave arrival time of a sensor is always significantly different (~260 µs) from that of the other sensors. This time difference is much greater than the P-wave travel time in the range of the experimental sample. Therefore, it can be inferred that there is a P-wave arrival time system error (PATSE) for each sensor. The PATSE may be due to a combined result of the sensor site effect and signal transfer delay time from the sensor to the signal storage. To handle this, a Bayesian inversion framework was built to estimate PATSEs. A synthetic test demonstrated the effectiveness of the proposed Bayesian method for noisy P-wave arrival time data. Then, Bayesian inversion was applied to 15 PLB events, which confirmed the existence of PATSE in an AE experiment for the first time. The average PATSE reached 1.47 µs without considering the P-wave arrival time significantly different sensor. The average location error of 25 PLB events was 14.30 mm and 6.58 mm for PATSE unremoved and removed data, respectively. To achieve this, a high-precision virtual field optimization location method (VFOM) was used. This demonstrates the necessity of removing the PATSEs. Finally, the AE event location performance for the PATSE unremoved and removed data was compared, where the AE events were obtained from the uniaxial compression of a red sandstone sample. The results indicated that there was a higher location detection success rate for the corrected data. The AE locations based on the corrected data were in a better correlation with the rock sample failure mode than that without correction. Moreover, increase the signal sampling frequency for AE event identification, use a real-time inverted 3D velocity model and update the PATSEs in real time could be used to further improve the AE event location accuracy.</p>

Estimation of Damage Location of Rock Based on Denoised Acoustic Emission Signals Using Wavelet Packet Algorithm

Real-time Damage Assessment of Hydrous Sandstone Based on Synergism of AE-CT Techniques

Research on AE Source Location of Linear and Plane Rock Mass

Time delay estimation and acoustic emission source location of rock based on phase difference

Acoustic emission source location based on wavelet transform de-noising

An Experimental Analysis for Damage Monitoring in Glass Fiber/Epoxy Composites During Fatigue Tests by Acoustic Emission

The EMD Analysis AE Signals of Rock Failure under Uniaxial Compression

A New Quantitative Acoustic Emission Model for Damage Characterization of Composite Laminates Using Original Waveforms

A new acoustic emission damage localization method using synchrosqueezed wavelet transforms picker and time-order method

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

Impact of Model Knowledge on Acoustic Emission Source Localization Accuracy

Arrival-Time Detection with Multiscale Wavelet Analysis and Source Location of Acoustic Emission in Rock

A Wideband Damage Source Localization Method Using Enhanced Virtual Time Reversal Mirror Technique and Modal Analysis with Sparse Acoustic Emission Array

Damage Evolution During Rock Dynamic Compression Revealed by Wavelet Analysis of Acoustic Emission Signals

A Damage Localization Approach for Concrete Structure Using Discrete Wavelet Transform of Electromechanical Admittance of Bonded PZT Transducers

An Improved Rock Damage Characterization Method Based on the Shortest Travel Time Optimization with Active Acoustic Testing

Combined application of acoustic emission and wavelet packet analysis on damage condition monitoring of structures

A Proposed Algorithm Based on Variance to Effectively Estimate Crack Source Localization in Solids

Rock Anisotropic Damage Characterisation and Its Evolution Model by Integrating Acoustic Emission Tomography and Ultrasonic Monitoring

Improving the Positioning Accuracy of Acoustic Emission Events by Optimizing the Sensor Deployment and First Arrival Signal Picking.

Determine the location of acoustic emission source on wood surface by using a wavelet-energy attenuation method