Abstract:Trihedral corner reflectors are being increasingly used as point targets in deformation monitoring studies using interferometric synthetic aperture radar (InSAR) techniques. The frequency and size dependence of the corner reflector Radar Cross Section (RCS) means that no single design can perform equally in all the possible imaging modes and radar frequencies available on the currently orbiting Synthetic Aperture Radar (SAR) satellites. Therefore, either a corner reflector design tailored to a specific data type or a compromise design for multiple data types is required. In this paper, I outline the practical and theoretical considerations that need to be made when designing appropriate radar targets, with a focus on supporting multi-frequency SAR data. These considerations are tested by performing field experiments on targets of different size using SAR images from TerraSAR-X, COSMO-SkyMed and RADARSAT-2. Phase noise behaviour in SAR images can be estimated by measuring the Signal-to-Clutter ratio (SCR) in individual SAR images. The measured SCR of a point target is dependent on its RCS performance and the influence of clutter near to the deployed target. The SCR is used as a metric to estimate the expected InSAR displacement error incurred by the design of each target and to validate these observations against theoretical expectations. I find that triangular trihedral corner reflectors as small as 1 m in dimension can achieve a displacement error magnitude of a tenth of a millimetre or less in medium-resolution X-band data. Much larger corner reflectors (2.5 m or greater) are required to achieve the same displacement error magnitude in medium-resolution C-band data. Compromise designs should aim to satisfy the requirements of the lowest SAR frequency to be used, providing that these targets will not saturate the sensor of the highest frequency to be used. Finally, accurate boresight alignment of the corner reflector can be critical to the overall target performance. Alignment accuracies better than 4° in azimuth and elevation will incur a minimal impact on the displacement error in X and C-band data.

Imaging Characteristics of Corner Reflector under Multi-Azimuth Angles

Analysis of Reflection Property of Cube-corner Retroreflector with Vector Expression

Research on SAR Image Corner Reflector Detection method

Analysis of corner reflector in SAR radiometric calibration

Coupling Scattering Characteristic Analysis of Dihedral Corner Reflectors in SAR Images

Research on Far-Field Diffraction of Cube-Corner Retroreflector in the Satellite Laser Ranging System

Bistatic Scattering Characteristic Analysis of Dihedral Corner Reflector

Optimization design of synthetic aperture radar corner reflector

Scattering Characteristics Of The Multi-Corner Reflector Based On Sbr Method

Analysis of Factors Influencing the Accuracy of CRDInSAR

Characteristics Analysis and Image Processing for Full-Polarization Synthetic Aperture Radar Based on Electromagnetic Scattering from Flat Horizontal Perfect Electric Conducting Reflector

Investigations of Effects of Geometric Characteristics on RCS for Corner Reflectors

On the Design of Radar Corner Reflectors for Deformation Monitoring in Multi-Frequency InSAR

Measuring Corner Cube Reflectors Through Ray Tracing Of A Reflected Wavefront

Accurate Analysis Of Target Characteristic In Bistatic Sar Images: A Dihedral Corner Reflectors Case

Bistatic RCS Characteristics of Corner Reflector in Time Domain

Three-Dimensional SAR with Fixed Transmitter and Its Scattering Explanation

Multichannel SAR with Reflector Antenna for High-Resolution Wide-SwathImaging

Analysis of THz Electromagnetic Characteristics for Passive Jamming Corner Reflectors

Design and Fabrication of Micro-Cube-Corner Array Retro-Reflectors

Polarimetric Calibration of Linear Dual-Pol SAR when Corner Reflectors Are Unavailable