Abstract:An efficient intersection signal scheme is of vital significance to urban traffic operation. At present, multiperiod fixed-timing control is still the traffic signal control method adopted by many urban intersections. For the optimization problem of signal scheme selection at signalized intersections, we proposed three two-step prediction optimization methods that match the traffic arrival in different periods with the corresponding optimal signal scheme, aimed at reducing the total delay of vehicles at signalized intersections. The first method predicts the traffic flow in each entrance direction of the intersection by minimizing the mean square error (MSE), then obtains the total vehicle delay of each scheme in the signal scheme set through the Highway Capacity Manual 2010 delay formula, and finally substitutes it into the signal optimization model to obtain the optimal scheme combination. The second method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing the MSE and then substitutes it into the signal optimization model to obtain the optimal scheme combination. The third method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing both the MSE and the prediction error between every two schemes and then substitutes it into the signal optimization model to obtain the optimal scheme combination. Verification based on actual intersection shows that better optimization results can be obtained by integrating optimization objectives into the prediction process. Besides, some practical insights can be drawn through applicability analysis and sensitivity analysis. First, the proposed model is more suitable for intersections where traffic arrivals vary greatly. Second, with the increase of scheme differences within a certain range, the advantages of the proposed method become more obvious. Finally, it is necessary to balance the flexibility of traffic control with control effectiveness in practical applications.

Comparison Between Two Methods of Signal Design for Cross Roundabouts

Signal control and simulation of a typical roundabout

Traffic Signal Control Optimization Strategy Based on Simulation

Proactive Coordination of Traffic Guidance and Signal Control for a Divergent Network

Comparing Roundabouts and Signalized Intersections Through Multiple-Model Simulation

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Analysis om waiting area for left-turn vehicles at signalized intersections

Urban Road Roundabout Method of Contrast Optimization and Research

Signal Optimization Method of Crosswalks Between Coordinated Intersections

Optimal Cycle Calculation Method of Signal Control at Roundabout

Minimum Cycle Length of Two-Phase Road Intersection

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Improvement of classical numerical method for arterial road signal coordinate control

Research on the Optimal Method of Cycle Length for Signalized Intersection

Bus signal priority method at arterial signal progression

Intersection Control Considering Channelized Section Spillback Using a Flexible Phase Plan

Coordination Control Strategy of Urban Expressway On-ramp and Off-ramp

Optimization Method of Signal Timing Parameters Considering Comprehensive Efficiency of All Approach Lanes

Research on signal control methods of traffic bottlenecks in city road network

Optimization of Two-Way Traffic Signal Timing Control