Design and Simulation of Arcless Breaking Based on Matlab

周建胜,丁桂甫,刘瑞,杨卓青

DOI: https://doi.org/10.3969/j.issn.1001-5531.2008.17.004

2008-01-01

Abstract:A new method, on the basis of parallel resists, was proposed to suppress the arc phenomena. Electric contact functions were divided into two processes, which are implemented by main contact and auxiliary contact respectively. Auxiliary contacts, which were realized by multi-contacts with resistances connected in series, were paralleled with the main switch. The series resistances limited each contact current to below the minimum arc discharge current for each arc discharge suppression. Auxiliary contact took on the dynamic process of contactor on and off and transfer the energy of possible arc, while the main contact took on the steady process of contact, avoiding any harm from the possible arc during the dynamic process and realizing contact without arc. The simulation in power system block of Matlab for 30 V/6 A breaking operation shows that the method is feasibile.