Abstract:Introduction: Surface electromyogram (sEMG) signals have been widely used in human upper limb force estimation and motion intention recognition. However, the electrocardiogram(ECG) artifact generated by the beating of the heart is a major factor that reduces the quality of the EMG signal when recording the sEMG signal from the muscle close to the heart. sEMG signals contaminated by ECG artifacts are difficult to be understood correctly. The objective of this paper is to effectively remove ECG artifacts from sEMG signals by a novel method. Methods: In this paper, sEMG and ECG signals of the biceps brachii, brachialis, and triceps muscle of the human upper limb will be collected respectively. Firstly, an improved multi-layer wavelet transform algorithm is used to preprocess the raw sEMG signal to remove the background noise and power frequency interference in the raw signal. Then, based on the theory of blind source separation analysis, an improved Fast-ICA algorithm was constructed to separate the denoising signals. Finally, an ECG discrimination algorithm was used to find and eliminate ECG signals in sEMG signals. This method consists of the following steps: 1) Acquisition of raw sEMG and ECG signals; 2) Decoupling the raw sEMG signal; 3) Fast-ICA-based signal component separation; 4) ECG artifact recognition and elimination. Results and discussion: The experimental results show that our method has a good effect on removing ECG artifacts from contaminated EMG signals. It can further improve the quality of EMG signals, which is of great significance for improving the accuracy of force estimation and motion intention recognition tasks. Compared with other state-of-the-art methods, our method can also provide the guiding significance for other biological signals.

A Study of Multi-Channel sEMG De-Noising and Aliasing Removal

A Method of Multi-Channel EMG Disposal Based on Wavelet Transform and Blind Signal Separation

Independent Component Analysis(ica) for Denoising EMG Signal from ECG Signal

Denoising Surface Electromyography Signals Based on Complementary Ensemble Empirical-Mode Decomposition and Multi-Scale Entropy

Wavelet transform and independent component analysis application to multi-channel SEMG processing

High-Density Surface EMG Denoising Using Independent Vector Analysis

De-noising method of the sEMG based on EMD autocorrelation

Denoising of Surface Electromyogram Based on Complementary Ensemble Empirical Mode Decomposition and Improved Interval Thresholding.

De-Noising Method of the Semg Based on EEMD and Second Generation Wavelet Transform

Removal of EMG Artifacts from Multichannel EEG Signals Using Combined Singular Spectrum Analysis and Canonical Correlation Analysis

Improving Method for Surface Electromyography Denoising Based on Wavelet Transform

An Adaptive Spatial Filtering Method for Multi-Channel EMG Artifact Removal During Functional Electrical Stimulation with Time-Variant Parameters.

[Surface Electromyogram Denoising Using Adaptive Wavelet Thresholding].

Power Frequency Noise-Reduction of SEMG Based on Independent Component Analysis

A Joint SSA and CNN Algorithm to Remove EMG Artifacts from Single Channel EEG

Surface electromyography signal denoising via EEMD and improved wavelet thresholds.

Improved multi-layer wavelet transform and blind source separation based ECG artifacts removal algorithm from the sEMG signal: in the case of upper limbs

Pretreatment of Semg Using Wavelet Threshold Method

EMG de-noising by multi-scale product coefficient hard thresholding

VMD-based Denoising Methods for Surface Electromyography Signals.

Semg De-Noising Based On The Lifting Wavelet Transform