Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Research on Different Carbon Doped Titania Visible Light Catalytic Activity

Visible-Light-Driven Titania/Silica Photocatalyst Co-Doped with Boron and Ferrum

Visible-light-driven Boron/ferrum/cerium/titania Photocatalyst

Facile Fabrication of N-doped TiO2 Nanocatalyst with Superior Performance under Visible Light Irradiation

Effect of Calcined Atmosphere on the Photocatalytic Activity of P-doped TiO2

Role of carbon in titania as visible-light photocatalyst prepared by flat-flame chemical vapor condensation method

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Preparation and Visible Light Photocatalytic Activity of Nitrogen-doped Nano-TiO_2 Powders

Low Temperature Preparation and Visible Light Photocatalytic Activity of Mesoporous Carbon-Doped Crystalline TiO2

Fabrication of V-Doped TiO2 Nanoparticles and Photocatalytic Studies under Visible Light

P-doped TiO2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

A systematic study on visible-light N-doped TiO 2 photocatalyst obtained from ethylenediamine by sol–gel method

Preparation and Properties Characterization of Visible-light-driven N-doped TiO2

Preparation of TiO2 Nanofibres and Influence of Calcination Temperature on Photocatalytic Activity

(Mo+n) Codoped TiO2 for Enhanced Visible-Light Photoactivity

Characterization and Visible-Light-Activity of Nitrogen-Doped Tio2 Photocatalyst

Highly efficient visible light TiO2 photocatalyst prepared by sol-gel method at temperatures lower than 300°C.

Simple Fabrication of Twist-Like Helix N,S-codoped Titania Photocatalyst with Visible-Light Response

Preparation and Characterization of Visible-Light-active Nitrogen-Doped TiO2 Photocatalyst.

The Fabrication and Characterization of Novel Carbon Doped TiO2nanotubes, Nanowires and Nanorods with High Visible Light Photocatalytic Activity