Abstract:The characteristics of longitudinal-torsional hybrid transducer-type ultrasonic motors (HTUSM) are low speed and high torque. The discontinuous-surface-contact mode between the stator and the rotor is different from the many-point-contact mode of traveling wave motors, which is also an essential cause for high torque. Therefore, it is important to analyze its force transfer model between the rotor and the stator. In this paper, issues of using the method of equivalent circuit model are addressed. The relationships between the contact angle, preload, and physical parameters of frictional materials are given, according to the impulse conservation law axially. The equations describing output torque, amplitudes of longitudinal and torsional vibration, and parameters of the rotor are derived according to the principle that the work done by the load is equal to that by the driving force in one vibrating cycle. All factors that influence the mechanical characteristics are analyzed, and accuracy and suitability of the force transfer model are verified by comparison with the prototype motor. The formula for transfer efficiency on the stator/rotor interface is given, and the low-efficiency of this type motor is explained. The wide-working frequency range property of this type motor is shown with experimental results. Based on this study, the parameters of the rotor and preload are determined. The maximum torque of the prototype motor is up to 13.2 nm, and no-load speed of this type of motor is 12.5 rpm.

Introduction of Electromagnetic Torque Increase of Hybrid Magnet-Circuit Multi-Coupling Motor

Field-circuit Coupled Design and Analysis for Permanent Magnet Synchronous Motor System Used in Electric Vehicles

Theoretical and Experimental Research on Hybridmagnetic-Circuit Multi-Couple Motor

Analysis the electromagnetic torque and magnetic field of the axial and radial air gap hybrid magnet circuit multi-coupling motor

Mechanism of hybrid-magnetic-circuit multi-couple motor

Torque Characteristics of Double-Stator Hybrid Stepping Motor with Serial Magnetic Circuit Structure

Design and Analysis of a Transverse-flux Permanent Magnet Motor With Hybrid Iron-core

Force Transfer Model and Characteristics of Hybrid Transducer Type Ultrasonic Motors

Static Torque Analysis and Calculation of Enhanced Hybrid Stepping Motor Based on ANSYS

Analyze the Position Sensor and the Axial Exciting Coil EMF of Axial and Radial Air Gap Hybrid Magnet Circuit Multi-Coupling Motor

ONLINEAR MODEL AND QUANTITATIVE ANALYSIS OF PERFORMANCE PARAMETER FOR THE AXIAL AND RADIAL AIR GAP HYBRID MAGNET CIRCUIT MULTI-COUPLING MOTOR

Torque Characteristic of Magnetic Flux Switching Hybrid Excitation Reluctance Motor

Analysis and Design of a Compound-Structure Permanent-Magnet Motor for Hybrid Electric Vehicles

ANALYSIS AND RESTRAIN STRATEGY OF COGGING TORQUE FOR DOUBLE-STATOR HYBRID DIRECT DRIVE MOTOR WITH SERIES MAGNETIC CIRCUIT

Magnetic Circuit And Torque Analysis Of A Brushless Transverse Flux Dual-Rotor Machine Used For Hevs

Analysis Method of Dynamic Torque-Frequency Characteristic of Hybrid Stepping Motors

Flux-weakening Control of Axial and Radial Air-Gap Hybrid Magnetic-Circuit Multi-Coupling Motor

A Study on Magnetic Decoupling of Compound-Structure Permanent-Magnet Motor for HEVs Application

Design and analysis of double-permanent-magnet enhanced hybrid stepping machine with tangential and radial magnetization

Torque System Modeling and Electromagnetic Coupling Characteristics Analysis of a Midpoint Injection Type Bearingless Permanent Synchronous Magnet Motor

Analysis of Multi-Objective Optimization Design of Interior Double Radial and Tangential Combined Magnetic Pole Permanent Magnet Drive Motor for Electric Vehicles