Abstract:The efficacy of steady large-amplitude blowing/suction on instability and transition control for a hypersonic flat plate boundary layer with Mach number 5.86 is investigated systematically. The influence of the blowing/suction flux and amplitude on instability is examined through direct numerical simulation and resolvent analysis. When a relatively small flux is used, the two-dimensional instability critical frequency that distinguishes the promotion/suppression mode effect closely aligns with the synchronisation frequency. For the oblique wave, as the spanwise wavenumber increases, the suppression effects would become weaker and the mode suppression bandwidth diminishes/increases in general in the blowing/suction control. Increasing the blowing/suction flux can effectively broaden the frequency bandwidth of disturbance suppression. The influence of amplitude on disturbance suppression is weak in a scenario of constant flux. To gain a deeper insight into disturbance suppression mechanism, momentum potential theory (MPT) and kinetic energy budget analysis are further employed in analysing disturbance evolution with and without control. When the disturbance is suppressed, the blowing induces the transport of certain acoustic components along the compression wave out of the boundary layer, whereas the suction does not. The velocity fluctuations are derived from the momentum fluctuations of the MPT. Compared with the momentum fluctuations, the evolutions indicated by each component's velocity fluctuations greatly facilitate the investigations of the acoustic nature of the second mode. The rapid variation of disturbance amplitude near the blowing is caused by the oscillations of the acoustic component and phase speed differences between vortical and thermal components. Kinetic energy budget analysis is performed to address the non-parallel effect of the boundary layer introduced by blowing/suction, which tends to suppress disturbances near the blowing. Moreover, viscous effects leading to energy dissipation are identified to be stronger in regions where the boundary layer is rapidly thickening. Finally, it is demonstrated that a flat plate boundary layer transition triggered by a random disturbance can be delayed by a blowing/suction combination control. The resolvent analysis further demonstrates that disturbances with frequencies that dominate the early transition stage are dampened in the controlled base flow.

THE INSTABILITY AND CONTROL OF COMPRESSIBLE CROSS FLOWS

Effects of compressibility correction onγ-Reθ transition model

Application of simplified threeGequation transition model in hypersonic flow

Boundary-layer Transition Prediction Using a Simplified Correlation-Based Model

Modelling Flow Transition in a Hypersonic Boundary Layer with Reynolds-averaged Navier-Stokes Approach

Secondary instability control of compressible flow by suction for a swept wing

A NEW TRANSITION/TURBULENCE MODEL FOR THE FLOW TRANSITION IN SUPERSONIC BOUNDARY LAYER

Instability and Transition Control by Steady Local Blowing/suction in a Hypersonic Boundary Layer

A Modular RANS Approach for Modeling Hypersonic Flow Transition on an Air-Breathing Configuration

Research on the influence of spanwise cross-flow on the boundary layer transition of compressor cascade

Progress in physical modeling of compressible wall-bounded turbulent flows

PROGRESS IN TURBULENCE/TRANSITION MODELLING

Active Transition Control by Synthetic Jets in a Hypersonic Boundary Layer

Modeling Supersonic and Hypersonic Flow Transition over Three-Dimensional Bodies

A modular RANS approach for modelling laminar-turbulent transition in turbomachinery flows

Boundary layer transition of hypersonic flow over a delta wing

Cross-flow Vortices and Their Secondary Instabilities in Hypersonic and High-Enthalpy Boundary Layers

Hopf Bifurcation and Transition of Three-Dimensional Wind-Driven Ocean Circulation Problem

Analysis of the secondary instability of the incompressible flows over a swept wing

Reverse transition of a turbulent boundary layer

Roughness-Induced Transition in Supersonic Boundary Layers with Wall Heating and Cooling Effects