Abstract:The need to provide efficient public transport services in urban areas has led to the implementation of bus priority measures in many congested cities. Much interest has recently centred on priority at signal controlled junctions, including the concept of pre-signals, where traffic signals are installed at or near the end of a with-flow bus lane to provide buses with priority access to the downstream junction. Although a number of pre-signals have now been installed in the U.K., particularly in London, there has been very little published research into their design, operation and optimisation. This paper addresses these points through the development of analytical procedures which allow pm-implementation evaluation of specific categories of pre-signals. The paper initially sets out three categories of pre-signal, which have different operating characteristics, different requirements for signalling and different impacts on capacity and delay. Key issues concerning signalling arrangements for these categories are then discussed, together with a summary of the analytical approach adopted and the assumptions required. Equations are developed to allow appropriate signal timings to be calculated for pre-signalised intersections. Further equations are then developed to enable delays to priority and nonpriority traffic, with and without pre-signals, to be estimated with delay being taken here as the key performance criterion. The paper concludes with three application examples illustrating how the equations are applied and the impacts of pre-signals in different situations. The analyses confirm the potential benefits of pre-signals, where these signals apply to non-priority traffic only. Where buses are also subject to a pre-signal, it is shown that disbenefits to buses can often occur, unless bus detectors are used to gain priority signalling. (C) 1998 Elsevier Science Ltd. All rights reserved.

Study on Design Methods of Pre-signals Based on Bus Priority of Intersections

Bus signal priority method at arterial signal progression

Development and Evaluation of a Passive Bus Signal Priority Algorithm at Isolated Intersection

Optimal signal-planning method of intersections based on bus priority

Multi-phase bus signal priority strategy at isolated intersections

Study of Vehicle Delay Calculation and Optimal Signal-planning Method for Intersections with Induced Signal Based on Bus Priority

Bus Priority Signal Control for Signalized Intersection without Bus Lane

Analysis of Vehicle Delay of Intersections with Pre-Signals Based on Bus Priority

Bus Priority Using pre-signals

Multiple-Phase Bus Signal Priority Strategy for Arterial Coordination Intersection

THE BENEFITS AND DISBENEFITS TO TRAFFIC AT PRE-SIGNALLED INTERSECTIONS

Conditional Active and Passive Bus Signal Priority Strategies Considering Saturation Degree Restriction at an Isolated Junction

An adaptive pre-signal setting to provide bus priority under a coordinated traffic-responsive network

Control Strategies for Transit Priority Based on Queue Modeling and Surrogate Testing

Providing Bus Priority Using Adaptive Pre-signals

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

An Approach of Transit Passive Priority with Transit Phase Overlapped at Intersection of Arterial Signal Progression

Optimization Method Based on Emission Factors of Signal Control for Bus Priority

Absolute minimum green calculation for vehicle phase at signalized intersections with bus rapid transit signal priority

Analysis om waiting area for left-turn vehicles at signalized intersections

Influence of signal on the capacity of signalized intersection