Abstract:An atypical face gear pair with complex transmission motion can be used in intermittent reciprocating mechanisms with more precise transmission and a much higher capacity than conventional mechanisms, such as cams and linkages. In this study, we derive a mathematical equation for the complex tooth surface of this gear pair. We indicate the change in root cutting, top sharpening and the effective width of the tooth surface with different parameters. Additionally, we derive the governing equation for the kinematical characteristics of this eccentric curve-face gear pair with a rigid–flexible coupling system, revealing the continuous intermittent contact principle of this gear type with different parameters. Boundary conditions for the gear pair are proposed, demonstrating that the vibration of the gear pair is more obvious, even at a low velocity. In addition, the critical velocity, which mostly ranges from 300 rpm to 400 rpm, is affected by the stiffness of the frames and the parameters of the tooth surfaces. The interval space and interval time of the intermittent contact system are Δd≤0.3 mm and Δt≤5.6×10−4 s, with visible surface sliding on the contact area. It is shown that the contact points are firstly concentrated at the outer part of the tooth surface and that the meshing will break off at the first tooth with the minimum inner radius RGi−min. These theoretical results, which have been verified experimentally, provide theoretical support for further analysis and the better application of this unconventional gear pair.

Mechanics Model of Cylinder Sine Oscillating Tooth Gear Drive

Meshing Theoretical Study and Simulation on Cylindrical Tri-sine Oscillating Tooth Gear Drive

Creative Design of Movable Tooth Gear Drives

Research on the Rotary-Linear Motion Magnetic Gear Based on Ansys

Study on force model of roller oscillating tooth gear drive

Precise modeling of complex tooth surface microtopography and multi-degree-of-freedom nonlinear friction dynamics for high-performance face gear

Fuzzy Reliability Research on Contact Strength of Cylinder Sine Oscillating Tooth Gear Drive

Torsional Vibration of Roller Oscillating Tooth Gear Drive

Modeling of Helical Gear Power Tri-Branching Transmission Based on Loaded Tooth Contact Analysis

Research on Kinematics Analysis and Sliding Ratio Calculation of Cylinder Dual-Sine Oscillating Tooth Gear Reducer

Investigation on Tooth Surface Wear of Cycloid Drives Considering Tooth Profile Modifications

A Semi-Analytical Load Distribution Model for Cycloid Drives with Tooth Profile and Longitudinal Modifications

A harmonic drive model considering geometry and internal interaction

Vibration characteristics analysis of face gear transmission system considering gyroscopic effect

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Non-Linear Dynamic Modeling and Experiment of Harmonic Gear Drive

Generation and Meshing Analysis of a New Type of Double Helical Gear Transmission

The Finite Element Modal Analysis of the Cosine Gear

A novel dynamic modeling method with slice coupling for thin-rimmed gear transmission

An Analysis of the Kinematical Characteristics of an Eccentric Curve-Face Gear Pair with Compound Motion

Mathematic model and tooth contact analysis of a new spiral non-circular bevel gear