Multiplicative Scatter Correction and Stepwise Regression to Build NIRS Model for Analysis of Soil Organic Carbon Content in Black Soil

申艳,张晓平,梁爱珍,时秀焕,范如芹,杨学明
DOI: https://doi.org/10.3969/j.issn.1001-0068.2010.02.010
2010-01-01
Abstract:Near infrared modeling based on the whole spectroscopy takes much work and the model may not be optimum because of too much tedious information.Wavelength selection through certain method could improve the model.Stepwise regression is usually used to select wavelengths with important information.Multiple scatter correction(MSC) technique can be used effectively to remove the effect of scatterings due to physical factors such as the density and humidity of samples and other factors caused by operators.A total of 136 Black Soil samples were obtained during 2004-2005 in Northeast China and corresponding infrared spectra from 3699-12000 cm-1 was measured using Fourier transform infrared spectrometry.Multiple scatter correction was used to preprocess the original spectra and multiple stepwise regression method was used to select wavelengths.Results showed that MSC can effectively decrease the scattering effect and thus enhance the signal to noise ratio.Compared to original spectrum,MSC improved the SOC quantitative model,with the determination coefficient increased from 0.598 to 0.681.Determination coefficients of model based on wavelengths chosen by experience was 0.956.Model based on wavelengths selected by hand was better than that based on wavelengths selected by stepwise regression analysis.Selecting wavelengths by stepwise regression analysis needs to be further studied.
What problem does this paper attempt to address?