Abstract:A novel coaxial mixer was proposed, which had an outer wall-scraping frame and a combined inner impeller consisting of a four-pitched-blade turbine paddle (PBT-4) and a Rushton turbine paddle (RT-6). Its heat transfer performance in Newtonian fluid under different operating modes (single rotation of inner impeller, corotation and counter-rotation) was experimentally investigated in a stainless steel agitated vessel with semicircle spiral jacket and ellipsoidal head by measuring the average heat transfer coefficient of the inner wall. Meanwhile, the wall temperature, the heat flow rate and the local heat transfer coefficient in the coaxial agitated vessel were determined with the help of numerical simulation. The results show that the heat transfer coefficient near the inner wall surface of the agitated vessel will increase with the increasing speed of the inner or outer impeller whether under single-shaft agitation or under coaxial agitation mode, whereas the effect of speed of the inner impeller on heat transfer is more obvious and efficient. Under the same conditions, the heat transfer of coaxial agitation is more efficient than that of single-shaft agitation, especially the local heat transfer coefficient on the upper and lower part of the agitated vessel, which is increased greatly. In addition, the local heat transfer coefficient varies with the axial position of the agitated vessel, and the heat transfer coefficient in zones between the upper and lower impeller is relatively high. The effect of the corotation mode and counter-rotation mode on heat transfer is of little difference, but the corotation mode is recommended owing to its advantage of low power consumption and good mixing performance.

Effect of Stirring on Liquid-Liquid Separation in Modified Mixer-Settlers

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Experimental Study on Micromixing Characteristics of Coaxial Mixer in Solid–Liquid Systems

Experimental Study on Micromixing Characteristics of Novel Large-Double-blade Impeller

Experimental Study on Coaxial Mixer Based on Critical Uniform Dispersion of Floating Particles

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Experimental Investigation on Drawdown of Floating Particles in Viscous Systems Driven by Coaxial Mixers

Numerical investigation on the intensification of coaxial slurry mixing systems

Numerical Study on the Synergistic Mechanism of Coaxial Mixers in Dense Solid-Liquid Mixing Systems

Experimental Study on the Mixing and Dispersing of Floating Particles in Viscous System

PIV Measurement and CFD Simulation of Liquid-Liquid Flow of a Settler in Rare Earths Solvent Extraction Mixer-Settler

PIV Measurement and CFD Simulation of Liquid-Liquid Mixing in Mixer Settler with Rigid-Flexible Impeller

Experimental Study of Influence of the Impeller Spacing on Flow Behaviour of Double‐Impeller Stirred Tank

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

Study on mixing and settling characteristics in mixer-settler

Micromixing Simulation of Novel Large-Double-Blade Impeller

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

Enhancement of Liquid–liquid Mixing in a Mixer-Settler by a Double Rigid-Flexible Combination Impeller

Structural Optimization of a Settler Via CFD Simulation in a Mixer-Settler

Research on Heat Transfer Performance of Coaxial Mixer with Inner Combined Impeller