Abstract:Furfural is considered to be one of the top 30 potential chemicals derived from lignocellulosic biomass. Compared to conventional diluted acid catalysis, furfural production from lignocellulose was significantly improved by the addition of an immiscible organic solvent into the diluted acid solution. However, high conversion is usually achieved under a high water/solid ratio (>1, v/m), and the furfural product is distributed in both the organic solvent phase and the aqueous phase, leading to difficulty of furfural recovery and increasing the cost of furfural production. The present work investigated corncob conversion in a diluted sulfuric acid-toluene biphasic system with extremely low water/solid ratios (≤1). It was found that a high furfural yield (65.67 mol%) was achieved in a very short time (10 min) under a high solid loading of 200% (in the aqueous phase) under the conditions of 1.5 MPa N2, 0.5:1 water/solid ratio (v/w), 10:1 toluene/solid ratio (v/m), and 3.85 wt% H2SO4 (in the aqueous phase). After the reaction, no aqueous phase existed, and furfural was completely accumulated in the toluene phase. Further research showed that the majority of the furfural content (84.73%, GC-MS detection) was in the toluene phase, which is beneficial for its recovery. This work provides an effective and inexpensive method for the production of furfural from lignocellulose.

Study on a new furfural preparation process based on steam-explosion way

Catalytic Decomposition of Furfural Residue with Dilute Sulfuric Acid to Produce Levulinic Acid in High Temperature Liquid Water

A New Process to Resource Rice Hull

Production of Furfural with High Yields from Corncob under Extremely Low Water/solid Ratios

Optimization Of Furfural Production From D-Xylose With Formic Acid As Catalyst In A Reactive Extraction System

A Two-Step Conversion of Corn Stover into Furfural and Levulinic Acid in a Water/Gamma-Valerolactone System

Studies on Pretreatment of Catalytic Cracking Slurry Oil with Added Furfural

Research on direct conversion of xylose to furfural in high temperature water

Conversion of Xylose Solution into Furfural at Atmospheric Pressure over the Solid Acid

Conversion of corn stalk into furfural using a novel heterogeneous strong acid catalyst in γ-valerolactone

Preparation of Furfural by Concorb Hydrolysis in Butyl Acetate-Water Biphasic System

Optimization of the Process of Furfural Preparation via Catalytic Hydrolysis of Corncob by Acid Salt

A Modified Biphasic System for the Dehydration of D-Xylose into Furfural Using SO42−/TiO2-ZrO2/La3+ As a Solid Catalyst

Study on Furfural Preparation by Utilizing Pentosan from Bamboo Fibre Preparation Process

A COMPARISON OF DIFFERENT DILUTE SOLUTION EXPLOSIONS PRETREATMENT FOR CONVERSION OF DISTILLERS' GRAINS INTO ETHANOL

Efficient Transformation of Corn Stover to Furfural Using P-Hydroxybenzenesulfonic Acid-Formaldehyde Resin Solid Acid.

Study on Extraction of Xylose from Sugar Cane Leaves with Steam Explosion

Physicochemical pretreatments and hydrolysis of furfural residues via carbon-based sulfonated solid acid

Preparation of Furfural and Reaction Kinetics of Xylose Dehydration to Furfural in High-Temperature Water

Recent Progress in Furfural Production from Hemicellulose and Its Derivatives: Conversion Mechanism, Catalytic System, Solvent Selection

The optimization of formic acid hydrolysis of xylose in furfural production.