Abstract:Bearings of rail vehicles bear various dynamic forces. Any fault of the bearing seriously threatens running safety. For fault diagnosis, vibration and temperature measured from the bogie and acoustic signals measured from trackside are often used. However, installing additional sensing devices on the bogie increases manufacturing cost while trackside monitoring is susceptible to ambient noise. For other application, structural displacement based on computer vision is widely applied for deflection measurement and damage identification of bridges. This article proposes to monitor the health condition of the rail vehicle bearings by detecting the displacement of bolts on the end cap of the bearing box. This study is performed based on an experimental platform of bearing systems. The displacement is monitored by computer vision, which can image real-time displacement of the bolts. The health condition of bearings is reflected by the amplitude of the detected displacement by phase correlation method which is separately studied by simulation. To improve the calculation rate, the computer vision only locally focuses on three bolts rather than the whole image. The displacement amplitudes of the bearing system in the vertical direction are derived by comparing the correlations of the image's gray-level co-occurrence matrix (GLCM). For verification, the measured displacement is checked against the measurement from laser displacement sensors, which shows that the displacement accuracy is 0.05 mm while improving calculation rate by 68%. This study also found that the displacement of the bearing system increases with the increase in rotational speed while decreasing with static load.

The on- line bearing inspection system based on machine vision

Automated Vision Inspection System for the Size Measurement of Workpieces

Non-Contact Vision Inspection System Of Geometric Dimension Based On Labview And Imaq Vision

Automatic Calibration System for Digital-Display Vibrometers Based on Machine Vision

A high-resolution detecting system based on machine vision for defects on large aperture and super-smooth surface

Research on bearing surface defect detection system based on machine vision

Design of On-line Automatic Vision Inspection System for Steel Billet Characters

State Monitoring and Fault Diagnosis for Pneumatic System Based on Machine Vision

Research of Image Analyse Based on Multi Axis Ultrasonic - Dectect System

The Ethernet-based Online Monitoring System and Its Application to Rolling Bearings

Fault Diagnosis Based on Multi-channel Vibration Signal for Port Machine Trolley Wheel Bearings

On-line Inspection System for Finished Circuit Board Based on Machine Vision

Multi-Sensor-Based Automatic Inspection System

Optimization Scheme of Measuring Accuracy of Bearing Seat Size Based on Machine Vision

Research and development of honeycomb ceramics' on-line automatic checkout system based on machine vision

Application of Computer-based Machine Vision Measurement System in Industrial On-line Detection

Displacement Identification by Computer Vision for Condition Monitoring of Rail Vehicle Bearings

Research on Industrial Online Detection Based on Machine Vision Measurement System

Smart Sensor-Based Monitoring Technology for Machinery Fault Detection

On-machine dimensional inspection: machine vision-based approach

Research on geometric dimension measurement system of shaft parts based on machine vision