Abstract:This study addresses the challenges faced by coal-fired power plants in adapting to energy fluctuations following the integration of renewable energy sources into the power grid. The flexible operation of thermal power plants has become a focal point in academic research. A numerical model of a coal-fired power plant was developed in this study using the Long Short-Term Memory (LSTM) algorithm and the Particle Swarm Optimization (PSO) algorithm based on actual operation data analysis. The combined PSO-LSTM approach improved the accuracy of the model by optimizing parameters. Validation of the model was performed using a Dymola physical simulation model, demonstrating that the PSO-LSTM coupled numerical model accurately simulates coal-fired power plant operations with a goodness of fit reaching 0.998. Overall system performance for comprehensively evaluating the rate and accuracy of unit operation is proposed. Furthermore, the model's capability to simulate the load variation process of automatic generation control (AGC) under different load command groups was assessed, aiding in optimizing the best load command group. Optimization experiments show that the performance index of output power is optimal within the experimental range when the set load starts and stops are the same and the power of load command γ = 1.8. Specifically, the 50–75% Turbine Heat Acceptance (THA) load rise process enhanced the overall system performance index by 55.1%, while the 75–50% THA load fall process improved the overall system performance index by 54.2%. These findings highlight the effectiveness of the PSO-LSTM approach in optimizing thermal power plant operations and enhancing system performance under varying load conditions.

Improved GPC Algorithm and Its Application in Thermal Power Plant Unit

Energy and exergy co optimization of IGCC with lower emissions based on fuzzy supervisory predictive control

Predictive Control and Economic Performance Optimization of CFBB Combustion Process

Development of a Three-Term MPC and Its Application to an Ultra-Supercritical Coal Fired Power Plant

Generalized Predictive Control for Superheated Steam Temperature Regulation in a Supercritical Coal-Fired Power Plant

Direct Algorithm for Coefficients of Generalized Predictive Controller

A Power Plant Coordinated Control System Using MPC

The Design and Application of the Generalized Predictive Control in the Strong Exothermic Reactor

Two-timescale Nonlinear Model Predictive Control for Flexible Operation of Coal-Fired Power Plant with Post Combustion CO2 2 Capture System

Research on fuzzy adaptive GPC of average coolant temperature based on regulation of boric acid concentration

Simulation test and parameter optimization of fast cut back of large thermal power plant in the condition of synchronization of large-scale wind power

Fuzzy PID Combined with Smith Predictor Control of GSHP Terminal Fan System

A practical predictive control algorithm for embedded system and its application

Model predictive control for an IGCC gasifier

A Novel Adaptive Generic Model Control Strategy for Internal Thermally Coupled Air Separation Columns with Multivariable Recursive Estimation.

Improved coordinated control strategy of coal-fired power units with coupled heat storage based on supercritical carbon dioxide cycle

Deep-learning modeling and control optimization framework for intelligent thermal power plants: A practice on superheated steam temperature

Predictive control strategy of a gas turbine for improvement of combined cycle power plant dynamic performance and efficiency

Optimization of the Load Command for a Coal-Fired Power Unit via Particle Swarm Optimization–Long Short-Term Memory Model

Train Control Algorithm Based on Generalized Predictive Control

An active disturbance rejection stair-like generalized predictive control with time delay weakening for denitrification process in thermal power unit