Abstract:In the current study, a three-dimensional measurement of the magnetic flux density was performed for a 280 mm width × 250 mm thickness continuous casting bloom mold installed with electromagnetic stirring with varied current intensity and frequency. The magnetic flux density increased gradually to a peak value and then decreased along the downward vertical direction, and it decreased in the transverse direction from the copper plate to the center of the mold. The electromagnetic field in the mold and the stirrer was calculated, and the node loading method was used to model the current input. The effect of the mesh size on calculation accuracy was investigated, and it was found that the 0.02-m cell size for the mold and the 0.001-m cell size for the coil conductor and the iron core were enough to achieve good agreement between the calculation and measurement. It was revealed that the stainless metal shell of the stirrer and the molten steel flow had little influence on the magnetic flux density. The following empirical equation was obtained to calculate the local magnetic flux density along the vertical distance: where B is the local magnetic flux density in mT, I is the current intensity in A , f is the current frequency in s −1 , N is the number of turns of coils, L is the vertical distance away from the center of the stirrer in m, L o is the height of the stirrer and was 0.35 m in the current study, and z o is the distance of the stirrer center below the mold top and was 0.665 m in the current study.

Numerical Simulation of Influence of Water Jacket of Soft -Contact Mold on the Distribution of Magnetic Field

Numerical Analysis of the Influences of Operational Parameters on the Fluid Flow in Mold with Hybrid Magnetic Fields

Numerical simulation study on the mold strength of magnetic mold casting based on a coupled electromagnetic-structural method

Numerical Simulation of Flow Field in the Continuous Casting Mold by EMBR

Numerical Simulation of Electromagnetic Field and Fluid Flow in Slab Continuous Casting Mold With Electromagnetic Stirring

Numerical Simulation of Flow, Heat, Solidification, Solute Transfer and Electromagnetic Field for Vertical Mold and Curved Mold of Billet

Numerical Simulation of Electromagnetic Stirring Field and Molten Steel Flow Field in Mold of Bloom Continuous Casting

Influence Of The Excitation Current In Traveling Magnetic Field On Mold Filling And Surface Depression Of Thin-Walled Casts

Numerical simulation on temperature field during soft-contact electromagnetic casting of round duraluminium alloy billets

Numerical simulation for mold-filling of thin-walled aluminum alloy castings in traveling magnetic field

Physical Simulation on the Liquid Metal Flow in FC-Mold of Slab Continuous Casting

Numerical Simulation of Electro-Magnetic and Flow Fields of Tial Melt under Electric Field

The simulation of mould metallurgical behaviour under electromagnetic stirring for vertical large bloom

Physical Simulation of Mold-Filling Processing of Thin-Walled Castings under Traveling Magnetic Field

Effects of Harmonic Electric Field Frequency on Electromagnetic and Flow Fields of Ti-Al Melt in A Rectangular Mold Based on Numerical Simulation

Numerical Simulation of Induction Heating System for Casting Moulds Used in Investment Casting

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Study on Traveling Magnetic Field Casting of Sheet Components

Study on Magnetic Field Distribution in Electromagnetic Ingot Casting Mold for Extra Heavy Plate

Measurement and Calculation of Magnetic Flux Density During Mold Electromagnetic Stirring on a Continuous Casting Bloom Mold

Numerical Simulation on Magnetic Flux Density in Direct Current Electromagnetic Pump