Influence of Liquid Type, Filler and Coupling Agent on the Interface Resistivity Between Silicone Rubber and Fiber Reinforced Plastic
Shuming Liu,Xidong Liang,Yingyan Liu,Qian Wang,Shuqi Liu,Zhou Zuo,Weining Bao,Yanfeng Gao,Shaohua Li
DOI: https://doi.org/10.1109/tdei.2021.009543
IF: 2.509
2021-01-01
IEEE Transactions on Dielectrics and Electrical Insulation
Abstract:The interface between silicone rubber (SR) and fiber reinforced plastic (FRP) is a weak point in composite insulator, which is easy to be affected by moisture. However, the corresponding evaluation methods and detection means are not complete yet. Based on the newly proposed method for measuring the interface resistivity with a four-electrode system, the influence of liquid type, filler and coupling agent on the interface resistivity are studied in this paper. It is found that the interface resistivity reduced by 2-4 orders of magnitude after permeation by deionized water, saline and low concentration nitric acid, but the variation trend of interface resistivity is specific when permeated in high concentration of nitric acid solution (1 mol/L). The experimental results of samples with and without silicone coupling agent (SCA) are compared and it is found that the interface without silane coupling agent is easier to be penetrated by liquid, and the change of interface resistivity is more obvious. Besides, the influence of moisture-sensitive Alumina Tri-hydrate and SiO2 fillers, which could provide paths for water and hydrated ions to permeate, on interface resistivity are analyzed. The experimental results are of great significance for the selection of the appropriate formula system and the prevention of liquid penetration for composite insulators.