Solid Forms of Bio-Based Monomer Salts for Polyamide 512 and Their Effect on Polymer Properties
Xiaohan Zhang,Xincao Fang,Yongliang Yan,Zihan Li,Qingshi Wen,Keke Zhang,Ming Li,Jinglan Wu,Pengpeng Yang,Junzhi Wang
DOI: https://doi.org/10.3390/polym16212953
IF: 5
2024-10-22
Polymers
Abstract:Polyamides' properties are greatly influenced by the polymerization process and the type of feedstock used. The solid forms of nylon salts play a significant role in determining the final characteristics of the material. This study focuses on the long-chain bio-nylon 512. Firstly, we systematically investigated the possible solid forms of the nylon 512 salt, including crystal forms and morphologies, by massive experimental screening, single-crystal X-ray diffraction, Hirshfeld surface analysis, and TG-DSC measurements. The regulation and control of the various solid forms were achieved through solid-state transformations (SSTs) and solution-mediated phase transformations (SMPTs). Our findings shows that the nylon 512 salt exists in two crystal forms (anhydrate and dihydrate) and four morphologies (needle-like, plate-like, rod-like, and massive block crystal). Many factors will influence the formation of these solid forms, such as water activity, temperature, solvent, and ultrasonic physical fields. We can choose the right factors to regulate this as needed. On this basis, we studied the effects of different solid forms (crystal forms and morphologies) on the properties of the resulting polyamides prepared using direct solid-state polymerization (DSSP). The solid form of the salt had many effects on the polymer, including its structure, melting point, and mechanical properties. The polyamide obtained through DSSP of the anhydrate salt exhibited a higher melting point (204.22 °C) and greater elastic modulus (3.366 GPa) compared to that of the dihydrate salt, especially for the anhydrate salt of plate-like crystals.
polymer science