Novel Ruthenium Sensitizers with a Phenothiazine Conjugated Bipyridyl Ligand for High-Efficiency Dye-Sensitized Solar Cells.

Zhijie She,Yangyang Cheng,Luoqiang Zhang,Xiaoyu Li,Di Wu,Qiang Guo,Jingbo Lan,Ruilin Wang,Jingsong You
DOI: https://doi.org/10.1021/acsami.5b09160
IF: 9.5
2015-01-01
ACS Applied Materials & Interfaces
Abstract:Two novel ruthenium sensitizers with a phenothiazine-modified bipyridine ligand, coded SCZ-1 and SCZ-2, have been synthesized and studied as dyes in dye-sensitized solar cells (DSSCs). Both dyes exhibit low-energy metal-ligand charge transfer (MLCT) bands centred at 539 nm with high molar extinction coefficients of 1.77 × 104 M-1 cm-1 for SCZ-1 and 1.66 × 104 M-1 cm-1 for SCZ-2, which are significantly higher than the corresponding value for the reference N719 (1.27 × 104 M-1 cm-1), indicating that the spectral response of ruthenium sensitizers can be reinforced by incorporating phenothiazine moieties into the bipyridine ligand. Photovoltaic devices using these sensitizers in conjunction with the I-/I3- electrolyte show impressive power conversion efficiencies (PCE) up to 10.4% under AM 1.5G irradiation (100 mW cm-2), which exceeds N719 (9.9%) under the same conditions. Both of the open circuit voltage (VOC) and fill factor (FF) of SCZ-sensitized cells approximate to those of N719-sensitized cell. The relatively higher efficiencies of the SCZ-sensitized solar cells than that of N719-sensitized cell come from their higher short-circuit photocurrent density (JSC), which may be mainly attributed to the high absorption coefficient. The absorption spectrum and device efficiency of SCZ-1 are both quite close to those of SCZ-2, suggesting that the difference in alkyl chains on the N atom of phenothiazine is not a decisive factor in affecting the photovoltaic performance of dyes.
What problem does this paper attempt to address?