From E-Waste to Nb-Pb Co-Doped and Pd-Loaded TiO2/BaTiO3 Heterostructure: Highly Efficient Photocatalytic Performance

Bo Niu,Zhenming Xu
DOI: https://doi.org/10.1002/cssc.201900071
IF: 8.4
2019-01-01
ChemSusChem
Abstract:A new and sustainable process was reported for the in situ synthesis of Nb-Pb co-doped and Pd-loaded TiO2/BaTiO3 nanometer heterostructures from waste multilayer ceramic capacitors through a simple chlorination-leaching route. The particle size of the Nb-Pb co-doped heterostructure and the Pd loading were 20-50 nm and less than 5 nm, respectively. The bandgaps of the prepared samples were in the range 2.81-2.92 eV. The optimal simulated-sunlight photocatalytic H-2 production rate and Rhodamine B degradation rate of the prepared heterostructure could reach 576.8 mu mol g(-1) h(-1) and 0.29911 min(-1), respectively, which were approximately 11.3 and 19.1 times higher than those of commercial TiO2, and 5.96 and 8.91 times higher than those of bare TiO2/BaTiO3. The recycled heterostructure exhibited excellent photostability and reusability. Such superior photocatalytic performance of the sample was attributed to the formation of the heterostructure, the Nb-Pb co-doping, and the Pd loading, which enhanced the visible light absorption and charge separation efficiency. Furthermore, DFT calculations were applied to explore the enhanced mechanism. This study demonstrates a sustainable process for the conversion of e-waste to a high-value-added and highefficiency photocatalyst, which has the advantages of waste utilization, low-cost preparation, and environmental protection.
What problem does this paper attempt to address?