Abstract:The experimental system is depicted in the ToC picture. First, we used a simple ultrasonic approach to create ionic liquid functionalized graphene (TSG‐IL). Second, during the PI preparation, a small quantity of TSG‐IL was added. Experimental results show that the thermal conductivity and mechanical characteristics of PI may be significantly enhanced at low additions of TSG‐IL. Polyimide (PI) has the inherent defect of poor intrinsic thermal conductivity and cannot meet the increasing demand for rapid heat dissipation in the thermal management introduction. To improve the thermal conductivity of PI, in this study, thick sheet graphene‐ionic liquid (TSG‐IL) functionalized graphene has been prepared by a one‐step ultrasonic‐chemical method. Under the action of mechanical force, IL is successfully modified on the surface of TSG, and TSG is peeled to some extent. TSG‐IL/PI has been prepared the typical method of solution casting followed by thermal imidization. The structure, morphology, thermal conductivity, and mechanical properties of the composites are evaluated by Fourier‐transform infrared spectroscopy, x‐ray diffraction analysis, scanning electron microscopy, transmission electron microscopy, and Hot Disk thermal conductivity tests. When the amount of TSG‐IL is 0.3 wt%, the thermal conductivity of TSG‐IL/PI (0.18 W·m−1·k−1) than pure PI and TSG (ultrasonication)/PI increased by 50.0% and 28.6%, respectively. Moreover, it can maintain good mechanical properties, and its tensile strength (121.5 MPa) is 6.5% and 3.5% higher than that of pure PI and TSG (ultrasonication)/PI, respectively. The potential for application in the preparation of composites with high‐thermal conductivity is promising.

Solvothermally Reduced Graphene Oxide/polyimide Composites: Structures and Thermal and Mechanical Properties

Fabrication, Optical and Electrical Properties of Solvethermal Reduced Graphene Oxide/polyimide Composites by in Situ Polymerization

Enhanced stress transfer and thermal properties of polyimide composites with covalent functionalized reduced graphene oxide

In situ thermally reduced graphene oxide/epoxy composites: thermal and mechanical properties

Preparation and Characterization of Strg/Pi Composite Films with Optimized Dielectric and Mechanical Properties

Dielectric and mechanical properties and thermal stability of polyimide–graphene oxide composite films

Molecular Design of Recyclable Thermosetting Polyimide and Its Composite with Excellent Mechanical and Tribological Properties

Mechanical, Electrical and Carbonization Properties of Graphene Oxide/polyimide Composite Films Prepared by Pre-in Situ Polymerization

In Situ Polymerization of Modified Graphene/polyimide Composite with Improved Mechanical and Thermal Properties

Structural Evolution, Induced Effects and Graphitization Mechanism of Reduced Graphene Oxide Sheets/polyimide Composites

Enhanced in-plane thermal conductivity of polyimide-based composites via in situ interfacial modification of graphene

Fabrication, Structure and Mechanism of Reduced Graphene Oxide-Based Carbon Composite Films

Preparation and properties of thermostable well-functionalized graphene oxide/polyimide composite films with high dielectric constant, low dielectric loss and high strength via in situ polymerization

Preparation and characteristics of composite films with functionalized graphene/polyimide

Polyhedral oligosilsesquioxane-modified boron nitride enhances the mechanical properties of polyimide nanocomposites

In Situ Fabrication of High Dielectric Constant Composite Films with Good Mechanical and Thermal Properties by Controlled Reduction

Mechanical, Thermal Conductive, and Dielectric Properties of Fluoroelastomer/reduced Graphene Oxide Composites in Situ Prepared by Solvent Thermal Reduction

Thermal, Mechanical and Dielectric Properties of Polyimide Composite Films by In-Situ Reduction of Fluorinated Graphene

Graphene oxide/polybenzimidazole composites fabricated by a solvent-exchange method

Lightweight, Mechanically Flexible and Thermally Superinsulating Rgo/polyimide Nanocomposite Foam with an Anisotropic Microstructure.

Enhanced Mechanical and Thermal Properties of Polyimide Films Based on Functional Groups-Free Few-Layer Graphene