Abstract:This paper investigates the evolution of the flow field and the load characteristics of a revolving body water entry at different angles of attack through experiments and numerical calculations. The experiment used a high-speed camera and pressure measurement devices to measure the flow field and surface pressure of water entry. A numerical calculation model was established using the computational fluid dynamics method and was used to simulate a test case. The results show that a change in the attack angle significantly affects the flow field and load characteristics of the revolving body. An increase in the angle reduces the cavity area on the upstream surface and delays the surface seal of the splash crown. The larger the angle, the smaller the difference between the peak impact pressures of adjacent cases, and the longer the time for the peak to reach a stable value (which increases approximately linearly). Meanwhile, the surface load of the revolving body is mainly concentrated around the cavity separation line, and the pressures before and after that line become dramatically different. The bottom surface load propagates from upstream to downstream in the form of ripples. Moreover, during the water entry process, the vortices around the body change from large scale to small scale. The vortices are densely attached to the surface and move upward along the test body. Interestingly, when the velocity field forms whirlpool at the wall, the surface pressure is usually less than the ambient pressure. These findings provide an important basis for a better understanding of the evolution of the flow field and surface load in the process of water entry, and further clarify the relationship between them.

Large Eddy Simulation and Experimental Investigation on the Cavity Dynamics and Vortex Evolution for Oblique Water Entry of a Cylinder

Numerical simulation of water entry of an inclined cylinder

Investigation on cylinder water entry in regular wave field using large eddy simulation

Numerical Simulation of Viscous Flow Past an Oscillating Square Cylinder Using A Cip-Based Model

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

Numerical study of vertical water entry of cylinder under the influence of wind and current

Numerical Study on the Vertical Water Exit of A Cylinder with Cavity

Numerical investigation on the cavity dynamics and multiphase flow field evolution for water entry of vertical cylindrical shell

Numerical Simulation on the Cavitation Flow of High Speed Oblique Water Entry of Revolution Body

Experimental and numerical studies on vertical water entry of a cylinder under the influence of current

A Numerical Study of Water Entry of Asymmetric Wedges Using a CIP-based Model

Experimental investigation on the multiphase flow characteristics of oblique water entry of semi-closed cylinder

Experimental investigation on the multiphase flow characteristics of oblique water entry of the hollow cylinders

Effects of entry angle on the water-entry cavity and motion hydrodynamics of a hollow cylinder

On the cavity flow of a cylinder exiting water obliquely

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

Numerical study on the fluid dynamics for tandem water entries of two cylinders

Cavitation bubble dynamics and structural loads of high-speed water entry of a cylinder using fluid-structure interaction method

Cavity dynamics of vertical water entry of a truncated cone–cylinder body with different angles of attack

Large-eddy Simulation of Vortex-Induced Vibration of a Circular Cylinder at Reynolds Number 10 000