Abstract:The char of three typical biomasses, rice straw char (RS char), chinar leaves char (CL char), and pine sawdust char (PS char), was prepared in a high-frequency furnace, which could efficiently reduce secondary reactions under rapid pyrolysis conditions at 800-1200 degrees C. The rapid pyrolysis char produced was isothermally gasified in a thermogravimetric analyzer (TGA) under a CO2 atmosphere. Effects of biomass type and pyrolysis temperature on intrinsic carbon structures and morphologic structures of char and further on gasification characteristics of char were investigated using a Raman spectrum analyzer, scanning electron microscopy (SEM), and a surface area and pore size distribution analyzer. Gasification kinetic models were also contrastively discussed under different conditions. Results show that gasification rates decrease with the increasing pyrolysis temperature. Under the morphologic characteristic reserved conditions, morphologic structures present obvious effects on gasification rates. Gasification reactivity of the three biomass chars is in the order of CL char > RS char > PS char. Melting and shrinkage happen during rapid pyrolysis of PS, and the disappearance of the pore and decrease of the specific surface area of PS char lead to the low specific surface area and gasification rates of PS char. Unobvious melting happens to RS char and CL char, and the initial physical structures can be almost reserved, while CL char presents larger porosity and specific surface area, which make its gasification rates higher than those of RS char. In most conditions, the random pore model (RPM) performs well to describe gasification rates of biomass char studied in this work. However, for gasification of PS char at high temperatures, during which high gasification rates can be maintained in high conversion ranges, the modified random pore model (M-RPM) performs better. For gasification of RS char and CL char at low temperatures, during which gasification rates present a sharp decrease and trailing in medium high conversion ranges, the shifted M-RPM performs better.

Effect of pyrolysis temperature on pine sawdust chars and their gasification reactivity mechanism with CO2

CO2 Gasification Kinetics of Biomass Char Derived from High-Temperature Rapid Pyrolysis

CO2 Gasification of Char from Raw and Torrefied Biomass: Reactivity, Kinetics and Mechanism Analysis.

Study on CO2 Gasification Characteristics of Pyrolysis Char from Pinewood Block and Pellet

Assessment of the Impact of Pyrolysis Conditions on Char Reactivity Through Orthogonal Experimental-Based Grey Relational Analysis

Synergistic Effect of Physicochemical Properties and Reaction Temperature on Gasification Reactivity of Walnut Shell Chars

EFFECT OF PYROLYSIS CONDITIONS ON THE STRUCTURE AND GASIFICATION REACTIVITY OF CHAR

Effects of Pyrolysis Atmosphere and Temperature on Coal Char Characteristics and Gasification Reactivity

Effect of microstructure of rapid pyrolysis char on its gasification reactivity

Effect of Pyrolysis Temperature on Characteristics of Biomass Char and Coal Char

Gas Emissions from Blends of Bituminous Coal and Biomass Chars under Different Pyrolysis Conditions

Structural and Gasification Kinetic Studies on Co-pyrolysis Chars of Coal and Biomass

Effects of pyrolysis pressure and atmosphere on gasification reactivity of Shenfu char

Decomposition and gasification of pyrolysis volatiles from pine wood through a bed of hot char

Gasification Reactivity of Rapid and Slow Pyrolyzed Shenfu Chars with CO2 at High Carbon Conversions and Elevated Temperatures

Study on CO2 Gasification Reactivity of Rice Straw Chars

Experimental and Kinetic Studies on the Intrinsic Reactivities of Rice Husk Char

Variation of the Crystalline Structure of Coal Char During Pyrolysis and Its Effect on Gasification Reactivity

Thermogravimetric and Kinetic Analysis of High-Temperature Thermal Conversion of Pine Wood Sawdust under CO2/Ar

CO 2 Gasification Reactivity of Char from High-Ash Biomass

Pyrolysis of the biomass in a rotary kiln II: Impacts of final pyrolysis temperature on product properties