TAA13. Treatment of Aortic Arch Diseases With Three Fenestrated Stent Grafts of In Situ Fenestration and Prefenestration

Zhao Liu,Min Zhou,Tong Qiao,Wei Wang,Chen Liu,Xiao‐Qiang Li,Changjian Li
DOI: https://doi.org/10.1016/j.jvs.2018.08.093
IF: 4.86
2018-01-01
Journal of Vascular Surgery
Abstract:The objective of this study was to summarize the recent experience and outcomes of total endovascular repair of complex aortic arch diseases with three fenestrated stent grafts of in situ fenestration and prefenestration. From February 2017 to June 2018, 3 patients with aortic arch aneurysm and 9 patients with arch dissection were admitted (average age, 61 years; 10 men and 2 women). According to the differences of lesions, in situ fenestration, prefenestration, or three-dimensional (3D) printing model guidance technique was used to perform the total endovascular repair. All patients underwent three fenestrations (Fig). All the procedures were completed in one stage with no conversion to open surgery. Average operation time was 5 hours. A novel bypass method was used intraoperatively for cerebral protection. No renal insufficiency or paraplegia occurred. One patient underwent postoperative cerebral infarction and hemiplegia. Retrograde dissection was found in one patient. Because of the difficulty of in situ fenestration, two patients were switched to the use of chimney technique. All patients with 3D printing model guidance were successfully fenestrated. Treatment of aortic arch lesions with in situ fenestration and prefenestration is a totally minimally invasive method, and the 3D printing technique can make the fenestrations accurate. The short-term follow-up shows safety and reliability, but further research and improvement are still needed.
What problem does this paper attempt to address?