Abstract:Background: The body area networks (BAN) are built by many wearable sensors to record, monitor or control the vital signals within the human body continuously. Human body communication (HBC) is a novel physical layer method to implement the BAN with low power consumption, low radiation, and strong anti-interference. However, the most existing HBC rarely consider the situation in which multiple sensors transmit data at the same time. Objective: The aim of this paper is to investigate the feasibility of frequency division multiplexing for human body communication multiplex data transmission. Methods: The signal was injected into the human body, and the human channel gain was measured by the spectrum analyzer. Two frequency signals were selected with smaller gain to design the transceiver. The transmitter used OOK modulation technology to design each functional unit, and the receiver recovered the original signal with a non-coherent demodulation method. Results: The experimental results show that after the dual signals were transmitted through the human body, the receiver could recover the original signal correctly. In both static and dynamic situations, even if the transmission rate was as high as 115.2 kb/s, the bit error rate was only 10-4. Conclusions: The frequency division multiplexing scheme can be selected for multi-channel data transmission in human body communication.

Research on Body Sensor Network Based on the Capacitive Coupling Intra-Body Communication Using a Mach-Zehnder Electro-Optical Sensor

Study on Signal Transmission Mechanism and Characteristic of Human Body Communication

The Sensitivity Characteristics of the Electrostatic Coupling Intra-Body Communication Based on the Mach-Zehnder Electro-Optic Modulation

A receiver analog front-end for body sensor network

Signal transmission in a human body medium-based body sensor network using a Mach-Zehnder electro-optical sensor.

A Method to Eliminate the Impact of Parasitic Capacitance for Intra-Body Communication Using Mach-Zehnder Electro-Optical Modulation

Modeling and Characterization of the Electrostatic Coupling Intra-Body Communication Based on Mach-Zehnder Electro-Optical Modulation.

Modeling and characterization of the implant intra-body communication based on capacitive coupling using a transfer function method.

Mathematical Simulation of the Implant Capacitive Coupling Intra-Body Communication Based on Transfer Function Method

The Simulation Of Electrostatic Coupling Intra-Body Communication Based On Finite-Element Models

The Finite-Element Simulation of the Intra-Body Communication Used in Wireless Body Area Networks

Review of the Modeling, Simulation and Implement of Intra-body Communication

Design and feasibility study of human body communication transceiver based on FDM

Research on Human Body Communication Channel Characteristics

An Investigation on Ground Electrodes of Capacitive Coupling Human Body Communication.

A Finite-Element Simulation Of Galvanic Coupling Intra-Body Communication Based On The Whole Human Body

An audio transmission system based on capacitive coupling intra-body communication

Intra-bodyhybrid communication scheme for healthcare systems

Matching Network to Improve the Transmission Level of Capacitive Intra-Body Communication (IBC) Channels

The Theoretical Analysis and FE Simulation of Electrostatic Coupling Intra-Body Communication Based on Upper Arm Model

Comparable Investigation of Characteristics for Implant Intra-Body Communication Based on Galvanic and Capacitive Coupling