Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Control Strategy for Arc-Suppression-Coil-Grounded Star-Connected Power Electronic Transformers

Collaborative Control Strategy of Power Electronic Transformer and Fault Current Limiter in DC Microgrid

Comprehensive Control Strategy and Robust Operation for Input Series Output Parallel Power Electronics Transformers in MVDC Grids

Control Strategies of a Multiport Power Electronic Transformer (PET) for DC Distribution Applications

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

An Individual Phase Current Control Strategy for the Single-Stage Medium-Frequency Isolated PET

A Comprehensive Suppression Strategy for Common Ground Circulating Current Caused by Grounding Fault in PV Modules

Control of a Three-Stage Three-Phase Cascaded Modular Power Electronic Transformer

DC Voltage Control Strategy of Three-Terminal Medium-Voltage Power Electronic Transformer-Based Soft Normally Open Points

Comparisons of different control strategies for 20kVA solid state transformer

Study on a New Resonant Grounding System

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

Modeling and Control of a Multiport Power Electronic Transformer (PET) for Electric Traction Applications

Research on Low Voltage Ride Through Strategy and Fault Calculation Equivalent Model of Power Electronic Transformer

Research on Topology and Control Strategy of Multi-Port Power Electrical Transformer

A Simple Online Fault Location and Tolerant Control Strategy for Power Electronic Transformers with a Single IGBT Open-Circuit Fault

Control Strategy for Single-Phase Open-Circuit Operation of a Modular Solid-State Transformer

An Effective Power Electronic Transformer Applied to Distribution System

A New Method of Active Arc Suppression for Single-Phase Grounding Fault in Distribution Network and Its Influencing Factors

A Novel Neutral Electromagnetic Hybrid Flexible Grounding Method in Distribution Networks

A Single Phase Power Electronic Transformer Considering Harmonic Compensation In Scott Traction System